Chevrolet Cruze Forums banner

Recent content by Snappa

  1. Retaining steering wheel controls

    Gen1 Audio & Electronics
    For those who added an after market radio to their 1 gen Cruze, were you able to successfully retain the steering wheel controls? I have all of the modules by AXXESS such as the gmos-044 and the ASWC-1. Everything works fine but I cannot program the steering wheel controls to work with my...
  2. Service power steering and stabilitrak after steering wheel swap.

    Gen1 Wheels, Tires, Brakes, & Suspension
    So no one has nothing on this?
  3. Service power steering and stabilitrak after steering wheel swap.

    Gen1 Wheels, Tires, Brakes, & Suspension
    Swapped my steering wheel out for one with button controls and now I have no power steering and messages on the dashboard. I’m assuming that this may be related to the clockspring spinning too much and now some type of steering sensor is out of wack. Is anyone else familiar with this?
  4. Questions jay concerning repairs at dealership

    General Discussion
    What years are affected by the recall? What is the recall number?
  5. Questions jay concerning repairs at dealership

    General Discussion
    When having your vehicle repaired at GM/Chevy dealership, are those repairs backed by a warranty? I had my oil pan gasket replaced due ton a leak and months later the leak has returned. Leak returned in under a year and only 5000 miles. Surely a proper oil pan gasket would last note than a few...
  6. Questions about torque converter seal replacement

    Gen1 Powertrain
    The seal is actually leaking, but it occurred almost right after having my torque converter seal replaced. The dealership was terrible. During the repair my car sustained damages to its body (2 dents and a small gauge in the paint) as well as multiple pieces missing and bolts not fully torqued...
  7. Questions about torque converter seal replacement

    Gen1 Powertrain
    When replacing the torque converter seal on a first gen automatic, do the axle shafts have to be removed from the transmission? I know the transmission has to be lowered and I order to do this do the dealerships/shops remove any of those?
  8. Polishing “chrome” trim under windows?

    Gen1 Appearance, Body, Detailing, & Interior
    I had the same issue with mine. Used Meguiars Scratch X 2.0 which is actually a mild paint cleaner. Made them look new again. Just as a tip, the portion of the silver trim that is on the rear quarter panel under the black triangular shaped accent is of a different material. Although it may look...
  9. Fuel line retainer question.

    General Discussion
    2011 Cruze LS. 1.8
  10. Damage while having Cruze services by GM/Chevrolet dealership.

    General Discussion
    Okay, instead of using this post to complain about my writing structure, how about actually providing some helpful advice that pertains to the issue I’m asking about. Now he had already made breaks in the paragraph, shouldn’t be any reason not to be able to read it after that. Probably ome...
  11. Fuel line retainer question.

    General Discussion
    so no one knows this?
  12. Damage while having Cruze services by GM/Chevrolet dealership.

    General Discussion
    On Tuesday, April 3rd 2018 I dropped my Cruze off for service which consisted of replacing a leaking valve cover gasket, oil pan gasket, and torque converter seal, all things that had to be replaced on a car that doesn’t even have 100,000 miles on it yet thanks to poor manufacturing by General...
  13. Parking brake lever issue...

    Gen1 Wheels, Tires, Brakes, & Suspension
    Turbo......
  14. Parking brake lever issue...

    Gen1 Wheels, Tires, Brakes, & Suspension
    The parking brake on my 1st gen Cruze is inconsistent in terms of where it stops when lifted. The rear brakes have already been cleaned and adjusted and work just fine when driving. I know some may think that’s the issue, however when that is the issue usually the parking brake is always travels...
  15. Brake retaining screws?

    Gen1 Wheels, Tires, Brakes, & Suspension
    Does anyone know the size or know of a replacement for the screws that hold the rear brake drum covers on? I know it isn’t required but I’d like to still have them. I have to drill out mine and they will need to be replaced.
Top