Okay fellas! When I start this project I'll make sure to take lots of pictures and document my steps as I go. I plan to pick up a kit like below from amazon.
https://www.amazon.ca/Machine-Plast...2G4N1Y42966&psc=1&refRID=PQZ0027VR2G4N1Y42966
I was also going to use my Dremel and probably buy a fiberglass/bondo repair kit. I will use the Dremel to do the cutting and shaping of the plastic and use the plastic welder and plastic welding rods to piece everything together. When it comes to filling in the marker lights and anything else I decide to fill, I will use the fiberglass/bondo repair kit.
The top and bottom grill will be cut horizontal in my design where it goes across the top and bottom of the bar with the Chevrolet symbol. I was going to try and cut these and use these pieces with the Dremel to shape and plastic welder to fill in the vertical spots where the bar used to be, then make sure it's secure and one piece and sand it down make it a nice finish and have it painted. I feel like this will be very easy to do it's make sure you have the proper measurements and getting it all lined up properly.
If you have any ideas or suggestions, I would gladly love to hear them!
