Chevrolet Cruze Forums banner
aagm44
1-15 of 15 Results
  1. Gen1 Audio & Electronics
    I purchased the PAC AA-GM44 to allow me to install an aftermarket amp and subs in my 2015 Eco without splicing wires, but I have a couple questions for those of you who have done this to your Cruze. 1.) Which set of the rca connectors did you use, or does it matter? 2.) How did you adjust the...
  2. Gen1 Audio & Electronics
    Title says it all. I already have an LC2i LOC from my last car and I'd like to do a clean, no splicing install. Are there other harnesses out there that work for our cars like this? I would actually like to run power from my amps through the stock speaker wiring if I can. Is there a harness that...
  3. Gen1 Audio & Electronics
    Hi everyone, I'm trying to install an amplifier in my 2015 cruze. I have all the wires ran, the amp is all set up and powers on, I just need to figure out the RCA cables and the remote wire. I purchased a PAC AA-GM44 with the understanding that this would give me RCA outputs for my stereo so...
  4. Gen1 Audio & Electronics
    Let me first start by saying I know very little about car audio, however, I can figure it out if given instructions. Secondly, I'm sure the same or similar question has been asked, but I'm struggling here. Here is what I have and what I've done already. The part I'm missing is what I need to...
  5. Gen1 Audio & Electronics
    Hello, I just recently finished an installing new front door speakers, tweeters, an amp and a mini DSP into my 2012 Cruze Eco. The system sounds great except for an alternator buzz I get, usually only noticeable at low to medium volumes. I am quite certain this noise is being introduced by the...
  6. Gen1 Audio & Electronics
    So my Cruze doesn't have the pioneer setup and I was wondering If someone makes a plug/play converter similar to this one but with six outputs? The first 4 would be the corner channels and last 2 would be the sub feed. I'd rather not run a pac aa-gm44 with a loc ontop. I don't want to burn the...
  7. Gen1 Audio & Electronics
    Hi Guys! I just want to add a power amp + subwoofer to my 2012 Cruze. Reading a lot this forum and I found two possible adapters: 1) PAC AA-GM44 Amplifier Integration Interface for Select 2010 and Up GM Vehicles at $30 2) PAC LP7-2 L.O.C. PRO Series 2-Channel Line Output Converter with...
  8. Gen1 Audio & Electronics
    Someone refresh my memory. Does this work with the MyLink deck in the Cruze?
  9. Gen1 Audio & Electronics
    FIRST OFF, I am only providing this "how-to" to make sure this is not what caused my brand new sub to pull a 3 miles island(melt -down)on me. SO , PLEASE DONT FOLLOW THIS UNTIL VERIFIED BY A KNOWLEDGEABLE POSTER. With that out of the way, I have posted a few pics to make sure this is an...
  10. Cruze Parts
    Selling my PAC AA-GM44 used in my 2012 Cruze for about a year. Works Perfect. Top cover doesn't like to stay snapped on so I have used electrical tape to hold it down. Sold the Cruze and just trying to get rid of some parts I no longer need. $20 shipped to continental US only. PM if interested.
  11. Gen1 Audio & Electronics
    2011/2012 Holden Cruze (Australian) Standard audio system with dvd/sat nav from factory. I have a 6 channel Line out converter, currently planning on Splicing it into the left hand side kick panel main loom above the big plug, I have found the speaker wiring but before I start cutting into...
  12. Gen1 Audio & Electronics
    So, is this something that will just plug directly into the factory harness, or will I need to splice wires from the factory harness?
  13. Gen1 Audio & Electronics
    Was pricing out my audio setup and came across this. The must have for adding an amp to your factory GM setup. $29.85 http://www.tigerdirect.com/applications/searchtools/item-details.asp?EdpNo=7198218&SRCCODE=WEBGOOPA&cm_mmc_o=mH4CjC7BBTkwCjCV1-CjCE&gclid=CNzj-YCl2LcCFSZgMgodyVgAuQ
  14. Gen1 Audio & Electronics
    Hi all. Does anyone know if the PAC AA-GM44 convertor will fit the Australian Holden Cruze? I'm trying to find out if the connectors are the same before ordering. Any help appreciated. Cheers, Peter
  15. Gen1 Audio & Electronics
    Greetings all. I am planning to install a small amp/sub setup in my 2012 Cruze and I have some questions about the PAC AA-GM44. 1. What are you to do with the pig tails (yellow & blue/black) on the AA-GM44? Do they need to be connected to 12v and ground? Seperate runs? Splice them back into the...
1-15 of 15 Results
Top