Chevrolet Cruze Forums banner
Cancel

Search Results for ‘apillar’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results

Search Tags

14l 14t 1lt 2011 2012 2013 2014 2015 2016 2017 aftermarket air audio auto back battery black bluetooth brake buy car change check chevrolet chevy code control coolant cotm cruze dealer diesel door eco engine exhaust filter fog forum front fuel gas gen headlights install intake interior issue issues kandn kit leak led light lights ltz manual member miles mpg mylink newbie noise obermd oil owner parts post power problem problems question questions radio rear replacement reported rims sale service side sound start steering stock system time tire tires today transmission trifecta trunk tune turbo upgrade warranty wheel wheels wtb
  1. Gen1 Audio, Electronics & Electrical
    So I had some work done..... Chevy Cruze A-Pillar Build - Car Audio | DiyMobileAudio.com | Car Stereo Forum
    apillar build cruze
  2. General Discussion
    Hello all, I've been interested in getting a boost gauge for my 2014 Cruze 2LT but have noticed all the A-Pillar gauge pods are for two gauges. Is anyone aware of a pop that has support for one gauge and one gauge only (think Cobalt SS/SC) thanks
    apillar gauge pod question
  3. Cruze Parts
    Like the title says. I've got the ZZP A-pillar pod. I was told it's the first release which has scratches. It does have a couple minor scratches. I will get pictures posted tomorrow. I need to charge my camera so I can attempt to take some close-up shots (phone's camera doesn't do it...
    1st 2010early 2011 apillar bar gauge pod rear release sway whiteline zzp
  4. Gen1 Appearance, Body, Detailing, & Interior
    I removed the A Pillar Molding today so that I could get to the tweeters. I browsed all of the threads I could find on how to remove this molding and everyone said to just pull it off. I tried to be as careful as possible, but the small plastic tabs on the molding all broke when I pulled it off...
    apillar damage molding
  5. Gen1 Appearance, Body, Detailing, & Interior
    Does anyone have any photos that demonstrate how to remove the 'A'-Pillar in a 2012 Chevy Cruze correctly without damage? I would like to route wires behind it.
    apillar remove
  6. Gen1 Audio, Electronics & Electrical
    I have a simple question: Does anyone know how to safely remove the interior trim piece on the a pillar? I need to run a "hardwire" behind it, and would rather not eat an airbag in the process. I normally would not ask, but I could not find anything relavant via a search.
    airbag apillar trim
1-6 of 6 Results
Top