Chevrolet Cruze Forums banner
blow
1-19 of 23 Results
  1. Gen1 1.4L Turbo
    Has anyone replaced or added anything like this to their 1.4l cruze? Is it difficult to DIY install these? Suggestions on BOV and /or Wastegate?
  2. Gen1 1.4L Turbo
    Hey everyone, I need some help with my 2011 Cruze. The valve cover had the typical failure where you can hear it sucking air, so she bought a new valve cover and I threw it on. There was also an issue with the corrugated hose that goes from the intake to the turbo. It was cracked so I replaced...
  3. Gen1 Audio & Electronics
    2014 cruze ltz rs turned on the car this morning and had the service park show up. 1.the lcd mylink display wont turn on. so black screen. no controls work on the center controls like radio controls ,navigation, power on off.of the my link. 2. the radio is stuck on which is a good thing i...
  4. Gen1 1.4L Turbo
    I have an opportunity to purchase a slightly used Forge Blow off Valve for a good price and wondered what benefit it will give me if I install it. Will I need to add other items to garner said benefits? Thanks in advance for any answers that hopefully help me out. (just trying to head off...
  5. General Discussion
    Hello all new here i had a serious issue with my 2013 Cruze. My coil pack blew out had three sparks and one spark plug damaged. Can the spark plug thread that was damaged be re threaded? Three of the new sparks tighten in but one doesn't.
  6. General Discussion
    Best place to purchase a blow motor cost wise? Used or New? does it matter?
  7. General Discussion
    My Blow motor wont come on....... Fuses are good, Relay's are good, Resistor is good ( bought a new one and it blow great for a few minutes then went off. No hot or cold air at all...............
  8. Gen1 Powertrain
    Just wondering will any after market blow off valve fit with the stock turbo? For example a hks bov.
  9. Fuel Economy
    If you start to notice spark blowout during WOT it's time to take care of your plugs. I wasn't able to get to my spark plugs for three weeks and I noticed my daily commuting fuel economy dropped by about 10%. Even though I don't drive in WOT that much the plugs weren't igniting the fuel as...
  10. Gen1 1.4L Turbo
    Okay, so I'm very new, so if this is posted in the wrong section or I just didn't research enough I apologize. I own a 2012 Cruze LT 1.4L Turbo, with about 85,000 miles on the engine.. I went for a drive tonight, on the freeway, and after about 5 or so minutes I noticed a loss of power going...
  11. Gen1 Diesel General Discussion
    Can you put on a blow off valve on the Diesel? I honestly do not have much knowledge on this sort of thing. If you can, which one should I get? Pros & cons?
  12. Cruze Parts
    For sale is a forge atmospheric blow off valve. Both springs included and the original box. It has approximately 5000 miles on it. It has been completely disassembled, cleaned, and reassembled with assembly lube. Ready to bolt on, as close to new as it gets without the price Asking $110...
  13. General Discussion
    Want to put a blow of valve on my 1.4l turbo anyone have any recommendations or could send links to different sites Sent from AutoGuide.com Free App
  14. Gen1 1.4L Turbo
    This is possible on a 1.4t automatic?
  15. Gen1 Powertrain
    With a Trifecta tune to remove the neutral 4000 RPM limit, you get to about 45 or so , drop to neutral, floor it to 6000-6500 and without lifting your foot put it into drive. If you did it right your needle will bounce like you're playing Need For Speed! *Yay totally worth it just for that and...
  16. Gen1 1.4L Turbo
    I juste bought a Chevrolet Cruze LT RS 1.4L turbo and I wanna add a blow off valve on it 'cause I wanna hear my turbo. But any place I call, they don't have a bov that fits my car. Any help please ??
  17. General Discussion
    hey guys, i have a blow-off valve on my cruze, not the stock , i add it on the piping of the intercooler but i need to plug ma vacuum of me bov on the vacuum of my car but not a vacuum suck , but a vacuum shoot pressur and not suck the pressure, do you know where is on the car??
  18. Lighting
    I installed the LED lights for the interior and license plate lights and started noticing the lights turn on white, and slowly turn blue if left on for 2+ minutes. I would think this is caused by the LEDs being overpowered and slowly burning out. I left my door open for 5-10 minutes and the dome...
  19. Gen1 1.4L Turbo
    Alright, so I went to change my oil today and realized oil across the lip of the valve cover. The only logical place the oil could have come from is from the fill tube. Is it possible with all the mods to push oil back up through the fill tube???
1-19 of 23 Results
Top