Chevrolet Cruze Forums banner
bypass
1-20 of 38 Results
  1. Gen2 Diesel General Discussion
    For the next couple weeks I'll be testing my auto stop / start bypass that would cost you a couple bucks in parts and a couple hours to install. It will require you to press a button each time you start the car. If it works flawlessly for me for the next few weeks I'll write up a brief how to...
  2. Gen1 1.4L Turbo
    Not a thread about needing help fixing something so not sure if it belong here but I plan to buy a used forge motorsports atmospheric by-pass valve tomorrow for $140 CAD. It comes with both green and yellow springs and the guy selling told me his car is tuned and the by-pass valve has 18,000kms...
  3. Gen1 1.4L Turbo
    So as the title states, I installed a cold air intake today (one of the longer ones, previously had a short ram) and now I was almost immediately met with a P1101 code. At the same time I also did installed a BNR (Forge) atmospheric bypass valve. There were no codes before the install...
  4. Titan Synthetics
    Looking into the pros of trying to install one in mine. Vs just a amsoil oil filter
  5. Gen2 Diesel General Discussion
    Thinking of going this route but need 1.6 gurus to inform me of pressure ports on the motor i can utilize
  6. Gen2 Powertrain
    BNR is proud to announce the immediate availability of our High Performance Bypass Valve for the Gen 2 Cruze 1.4T! Faster Spool More boost, sooner More boost, longer Increased throttle response MUCH louder chirp/blow off sounds from the turbocharger, especially with an aftermarket intake...
  7. Gen1 Service Issues
    Hello, 2012 Cruze LT owner. 120k miles. I am trying bypass my check engine light so my automatic (factory) car starter will work. I've had the check engine light problem fixed by the garage. It was the P0299 Engine Under Boost. However the code keeps appearing. I took it back to the garage...
  8. Gen1 Audio & Electronics
    i have a tesla style radio will the micro bypass work for tv to work i think after watching other video i did something stupid i thought if i grounded the parking brake wire i would complete the circuit i think im wrong thx
  9. Gen1 Engine/Transmission Tutorials
    How-To: Install Clutch Accumulator Bypass Mod Overview: The clutch on the 2011-2016 Limited Cruze uses two components to soften shifts and protect the drivetrain from beginners. First is the CDV (clutch delay valve, technically a restrictor), which limits clutch fluid flow. This is done to...
  10. Gen1 1.4L Turbo
    Ever since I have swapped my engine, I get a p2261 error. It is the same bypass valve on the same turbo assembly as the old engine. I have checked the electrical and vacuum connections multiple times. The weird thing is that it seems to work OK. The boost seems well controlled. I can feel the...
  11. TRIFECTA Performance
    With our recent unveiling of FPCM (fuel pump control module) / CCM (chassis control module) recalibration to support larger injectors on the 1.4T, another idea struck us. Could we also recalibrate the FPCM/CCM to allow the addition of dual mode exhaust valves to the Gen1 Chevrolet Cruze /...
  12. Gen1 1.4L Turbo
    I own and drive a 2012 Cruze 1.4L and my check engine light came on and the code came back something to do with my bypass valve. I have called around town and no on ecould find the location of the bypass valve or could tell me a definite answer as to why that code could be popping up. So I was...
  13. Gen1 Diesel Technical Discussion
    Hey everyone, I've been reading and searching the forum but had no luck finding info on this. Has anyone installed one on their 2.0 CTD? I fabbed up a bracket for my amsoil single filter bypass assembly and now I'm looking for info on where to tap into the oiling system. I'd like to locate the...
  14. Gen1 Diesel General Discussion
    Has anyone figured out how to bypass the emission sensors and the exhaust fluid?
  15. Cruze Parts
    Does anyone have a forge bypass valve or ecu reader for sale?
  16. General Discussion
    Hi all! I have been part of a couple BNR group buys around here (for the trifecta tune & shark fin) and I was wondering if there is enough interest in the atmospheric bypass valve to get another one going. I know that Jerry from BNR is usually who deals with this stuff, but just wanted to pull...
  17. Bad News Racing
    Hello, I have contacted, usps, Canada post, Canadian customs, and BNR, nobody knows where my bpv is but it mysteriously disappeared out of the package it was sent in. I received the EZ flash cable but not the BPV that was supposedly shipped with it, BNR hasn't responded and everyone else doesn't...
  18. Gen1 1.4L Turbo
    Hello fellows, I’m a newbie here. The car is 2013 1.4LT automatic, all stock. I have recently noticed that BSV operated when it should not – when only ignition key is on and the engine is not running. I kept the ignition on for a longer while but BSV never stopped modulating. The car is...
  19. Gen1 1.4L Turbo
    So I've just recently started modding my 2012 Cruze 1.4t. As of now I have the K&N Typhoon CAI and I absolutely love it. Just recently I went ahead and re-ran the vac lines to the bpv (plugging the solenoid of course) No CEL, No drive ability issues. Noticed improved throttle response in higher...
  20. Gen1 1.4L Turbo
    I was wondering if anyone is interested in trying to get the Forged Atmospheric Bypass Valve for anyone that has the Trifecta tune??
1-20 of 38 Results
Top