Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-18 of 50 Results
  1. General Discussion
    ENJOY! 1. The much anticipated package arrived. 2. The Contents 3. Spare Parts? 4. There it is! 5. The Y-Pipe 6. All Out 7. The Shortside Tip 8. The Longside 9. The Muffler 10. The Hardware Pack 11. Who Reads the Instructions! 12. What Could Possibly Go Wrong?
  2. General Discussion
    Hey folks. I just replaced the turbo charger on my '13 cruze eco and im noticing white smoke and a burning smell from the catalytic converter side of the turbo. I checked the exhaust and i dont see any smoke coming from there. Could the cat be clogged?
  3. Gen1 Service Issues
    2015 2LT, AT, 67k miles, no CEL or codes After making some PCV system repairs today, I turned the engine on and revved it a bit for a minute or so. Once I shut it off, I heard what sounded like a rapid drip-drip-drip noise in the engine bay, maybe from near the driver's side of the engine...
  4. Gen2 Diesel General Discussion
    I found this as an option for L5P Duramax engines: This is more expensive than fuel filter options for prior Duramax engines. It used to be about $80 to convert to a Cat 2 micron fuel filter.
  5. Cruze Parts
    Hey I own a 2011 Chevy Cruze Eco 1.4l. Looking for the front cat that connects directly to the turbo. I know I could buy one new for over $250 just thought I'd see if anyone had a used one that was cheaper. Thanks!
  6. Cruze Parts
    Car had 66,000 miles. Honeycomb is excellent. 2 studs are broken. $150 plus shipping. They are over $600 from the dealer and recyclers give $100-$120. Also have the rear cat.
  7. Cruze Parts
    I need the front O2 housing/catalytic converter for a first generation Cruze 1.4L
  8. Gen1 Appearance, Body, Detailing, & Interior
    I’m looking to get a cat back for my 2014 Eco soon, I’m looking for one on the cheaper side but it still has to be good quality. It must be one that is louder than stock but isn’t annoying as my Cruze is my only car and I use it to commute and take long trips, so it’s got to be relatively quiet...
  9. General Discussion
    Hello' Hoping I can get some advice..i have a 2011 cruze 1.4 turbo with 153,xxx miles and cant get rid of this p0420 code. Ive had the up and downstream 02 sensors replaced, ive had the cat replaced and ive replaced the turbo. I dont know what could be throwing this also getting the...
  10. General Discussion
    What is the going rate to install a cat back exhaust on a TruBendz single pipe 13 Chevy Cruze?
  11. Gen1 1.4L Turbo
    Hi. I'm new here but I have a question for everyone. I have a 2014 Cruze 1.4 with a K&N intake and Trifecta tune. Would I gain anything going cat free? Also losing that back pressure from the cat would it need to get retuned. Sent from my SM-G950U using Tapatalk
  12. General Discussion
    Hi all. I recently bought a chev cruze 1.6ls. The previous owner took the original cat out. Now the engine light is on and when you drive and stop and start again the car idles not constant and you smell fuel. Someone people said you need 2 mini cats and some say it only needs one on the...
  13. CruzeTalk New Member Introductions
    Hi all! I have a 2013 Cruze LT with 80k. The check engine light came on, and it gave me a catalyst inefficiency code. So, I changed the down stream HO2 sensor. The light stayed off for a few days, then came back on. I'm getting the following codes: P0137 - HO2S circuit low voltage sensor 2...
  14. Gen1 Powertrain
    Hey I'm just looking at getting a down pipe and cat delete I'm wondering if I can do this with out a tune. I know on other Vehicles (my 370z) I was able to delete cats and trick ecu with a spark plug defouler. Is this the same on a Cruze? I know I know I don't need your heat for cat delete I'm...
  15. Gen1 Powertrain
    Didn't know if anyone has seen this... Flowmaster Force II Cat-back For Chevy Cruze | GM Authority
  16. Gen1 1.8L
    How much would it cost (and should I spend the money) on getting cat back exhaust for my 2012 Chevy Cruze LS?
  17. Gen1 1.4L Turbo
    Hey guys (and girls) I do all my own exhaust work on all my vehicles and I was wondering if just deleting the second cat would set the CEL ... There's no o2 sensor after the second cat of I remember correctly but someone told me hat it would still set the CEL somehow .. Thanks in advance
  18. Gen1 1.4L Turbo
    Hello guys. Is it possible a cat could have fallen apart and not rattle? My car is louder then stock but the exhaust is stock. Is it also possible to have a failing turbo and because of this the exhaust may sound louder? No codes set at all No modifications have been done Also fixed lines...
1-18 of 50 Results