Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 257 Results
  1. Gen1 1.4L Turbo
    I am still fighting this issue... lack of power, and no CEL, or even pending codes. and it is hit and miss too boot. sometimes it is fine, other times its not. Here is what I have done. 1. pressure checked for air leaks... 2. tune up using OEM spark plugs about 15K miles ago 3. New turbo...
  2. Gen1 1.4L Turbo
    I haven't been able to find any topics discussing this. I was wanting to check the fluid level in my manual transmission because it has been hard to shift in gears 1-3 at lower speeds. I'm running amsoil 75-90 transaxel and Mt fluid that is about 1.5 yrs old. I just can't remember if...
  3. Gen1 1.4L Turbo
    Check engine light on. Code p01101(MAF) cHECK ENGINE LIGHT RESETS ON ITS OWN ONCE IN A WHILE. Replaced MAF sensor and air filter. Cleared code with code reader. Same problem. PCV checks ok and can't find any vacuum leaks using carb cleaner. Engine runs fine but after a few drive cycles...
  4. Gen2 Diesel General Discussion
    Question for the board On the way home the check engine light came on, and the car went into limp mode due to low DEF. I filled the DEF tank and now the car runs (seemingly) fine, but the check engine light is still on. Also, the remote start function on the car no longer works. Are these...
  5. Gen1 1.4L Turbo
    Good day, It is that time to replace the cutch on my 2011 ECO MT. I have a BNR tune, full exhaust, CAI. Below are the links and Part Numbers I intend to purchase. Would anyone mind verifying I have the correct part numbers? I think we are all on the same page as far as this being a good...
  6. Gen1 Service Issues
    Hi all, i tried to search to see if anyone else had mentioned this and i didnt notice a thread, so apologies if i missed it. I have 2012 1.4 lt turbo and the check engine oil soon notice up, im going to do the oil drain and refill and filter swap myself, but i noticed i dont have the menu...
  7. Gen1 Service Issues
    Hello, 2012 Cruze LT owner. 120k miles. I am trying bypass my check engine light so my automatic (factory) car starter will work. I've had the check engine light problem fixed by the garage. It was the P0299 Engine Under Boost. However the code keeps appearing. I took it back to the garage...
  8. Gen1 Wheels, Tires, Brakes, & Suspension
    Had an oil and coolant leak, a few weeks back, got those fixed, only to have the "Check Engine" light come ON on Monday, and the "Service Stabilitrak" message to show up TODAY. Had oil changed after they fixed the oil leak, and I did the coolant leak ("Water Outlet Valve") replacement/repair...
  9. Gen2 Service Issues
    so this is weird where my original thread any replies to it seem hidden and I can look at post history but not get the entire story. https://www.cruzetalk.com/forum/369-gen2-service-issues/233121-check-engine-p015b-again.html 02-13-2019, 10:59 AM...
  10. Gen1 Service Issues
    Hello all. I received the p0496 Purge valve code last week. I bought a new purge valve and put it on but the check engine light is still on. Will it turn off automatically or do I need to have it reset? I really don't want to take it to the dealer because I have put over $3000 in it last year...
  11. Vendor Spotlight! Great Deals for Members
    Been a while since we did the rounds of Kickstarter and Indiegogo, and after sifting through this afternoon we found three clever new auto accessories that are at the very least worth taking a closer look at. The first of the pack is the most practical, but as you work down the list they get a...
  12. Gen2 Diesel General Discussion
    How can I check to make sure all glow plugs in an engine are functioning properly? Does the ECU display any error messages? Yesterday (during the polar vortex) it was -20°F when I started my car to leave from work. The starter engaged for a good 3-4 seconds and then the starter continued to...
  13. Gen1 Service Issues
    I recently had my 2015 Chevrolet Cruze checked for what smelled like my engine burning. The original mechanic replaced the heating hose and said it had cracked. I took my car back to the same mechanic a week later and said it still smelled like something under the hood was burning. He identified...
  14. Gen1 Audio, Electronics & Electrical
    So I recently swapped the ZZP 02/midpipe combo for the stock downpipe/midpipe. When I installed the aftermarket exhaust the check engine light. I knew it was going to turn on as it is stated on their website. Well when I switched it for the stock setup the light is still there. Not sure if...
  15. Gen2 Diesel General Discussion
    2018 RS Hatch 6MT Diesel with 15K on it. Just threw this code. Went to Napa for a free scan before heading to the dealer. Their scanner through some generic info with no details, likely an OEM code? One thing I did notice was the DEF level indicator was not reading that day but is showing...
  16. Vendor Spotlight! Great Deals for Members
    Need some automotive artwork to spruce up the garage, den, or anywhere else in the house? These technical-style chalk drawings are printed on metal plates in three different sizes, and with over 125 prints to choose from, there will be something in the mix for every shade of auto enthusiast...
  17. General Discussion
    Hey guys, so I recently put in a low mileage long block in my 2014 1.4t due to a cracked piston. It's been running for about a month now with no issues at all. But I noticed tonight it's burning oil and there's oil on top of the intake manifold and there's a decent amount of oil in My catch...
  18. Gen1 Powertrain
    My CEL came on about a week ago, knowing the gas cap problem is the 1st likely issue I took it off and put it back, the code cleared the next day. Ive driven it fine for 2 days and this morning it came back on? Am I incorrect in thinking that if it was a sensor issue, the light would've not...
  19. Gen2 Service Issues
    had check engine light on other day i scanned it and cleared it and it came back again next day so took it to the dealer i believe it was p0105b. Dealer fixed it and said ecm needed an update? lol they replaced/fixed the engine due to bad cylinder number 1 a few weeks ago so maybe they forgot...
  20. Gen1 Powertrain
    Its been a rough two weeks for my 2014 chevy cruze. first had underboost code and dealer said the turbo was shot and got it replaced under warranty. Got car back last monday and driving home last night it started squealing and engine light came on. dealer replaced valve cover cause of pcv valve...
1-20 of 257 Results
Top