Chevrolet Cruze Forums banner
cold air intake
1-13 of 13 Results
  1. Gen1 Service Issues
    Installed a cold air intake on my 13 1.4T. Anyone have issues with the pcm not compensating for the extra air flow ? I am super confused as to why the air induction cross measurement is out of range. And tunes out there ? Any help or advice ?
  2. Gen2 Powertrain
    Does anyone have any suggestions for cold air intakes and other things to make the car sounds more aggressive? Also where to buy. ,Thanks in advance.
  3. Cruze Parts
    Selling a cold air intake for a 2011-2014 1.4L Turbo Cruze. Practically new. Used for not more than 5-10,000 miles. Freshly cleaned and oiled up. Ready to install. California Smog Legal. CARB#: D-269-49 See it here at Summit...
  4. Gen2 Powertrain
    Hey, I got a K&N Typhoon ( intake coming in on Wednesday and I wanted to get some things clear. I've seen on the forum that you have to disconnect the negative battery terminal when you install it or else you will...
  5. Gen2 Powertrain
    This question has probably been answered somewhere on here, so I apologize if I'm beating a dead horse here...anyways, does the K&N Typhoon part # 69-4521TS fit the 2016.5's LE2? I had one on my 1st Gen Cruze and would love to be able to hear the turbo a little better on my 2nd Gen. Thanks in...
  6. Gen1 1.4L Turbo
    So my understanding of a tune is changing the way the computer tells the car to perform. As basic as that it, that's pretty much ALL that I understand. I'm new to forums in general so i may have not found a thread that already explains all of this but i would really like some info. First off, I...
  7. Gen1 1.4L Turbo
    Hello everyone, so I have a real issue. I installed a CAI and it was running fine for about 30 miles, than a check engine like turned on, and now my idle is jumping up and down, and whenever my car builds boost, I can hear it release all of it and I cannot get it past 2ibs of boost now.. what's...
  8. Gen1 1.4L Turbo
    So recently I've been trying to find a way to convert my K&N "Cold Air Filter System" aka Short Ram Intake (In the engine bay), to an actual CAI system. The MAF sensor / IAT sensor needs to stay near the filter so I will be relocating the whole K&N system into the wheel well. Under where the old...
  9. General Discussion
    Hey Everyone, I just bought my second Cruze, I totaled my first one (I was not at fault). Anyway, I bought a 1.4L 2014 (eco turbo) and I want to get a cold air intake for it. I was wondering what are some good options for this car. What are all of you using? Do you notice any pickup in...
  10. Cruze Parts
    So I'm looking to sell my K&N SRI I had in my 2012 Cruze. I've used it for about two tanks of gas and I just decided it's a little loud for my liking. (BOV noise) I still have the box and will ship it in the original box with all the instructions. Everything is as good as new. This is the...
  11. Gen1 1.8L
    Well I live in Canada, so snow is going to be everywhere before you know it. I currently have my CAI, but I'm worrying about keeping it for the winter, should I go to SRI for the season? Should I completly remove it? Keep it? Any suggestions and help with reasons would help. I realised where...
  12. Gen1 1.4L Turbo
    for $700 sounds like a good deal. Bad News Racing Cruze 1.4T Stage 1 Kit, Bad News Racing Any opinions would be appreciated
  13. General Discussion
    Well is there a problem with installing one on a 2011 1.8L LS with injen cold air intake? I read its better to install one with the cai but i dont read anywhere about maf's for a 1.8l only the 1.4l but when i bought the maf dude said its for my cruze. Any help please.
1-13 of 13 Results