Can anyone help me figure out how to disconnect this yellow connector underneath the drivers/passenger front seats? I slid the red part to the left but after that I honestly didn't want to play with it too much so figured I'd see if I can get some help instead of messing it up potentially.

Do any of you know how to properly disconnect this connector? I do not want to break it. I have a theory that it is something to do with the tab that I have pointed to in the second picture. This is the connector for the blind spot module (located in the rear bumper fascia). Thanks for your help!

Here a stupid question - desire to replace my 2015 factory headlights with HID lights - trying to do the first step and disconnect the main wiring plug from the factory light. I've pulled out the little gray locking tab, but cannot remove the wiring plug from the light... it will not come lose -...

So I was installing a two-way radio in my vehicle, and needed to disconnect the battery to connect the wiring for it. When I got everything connected back up, I realized my compass showed "CAL", my tire pressures were blank and my outside air temperature indicator was blank. After a short drive...

Hi I've done a bit of searching and come up with varying answers for GMs, but not specific to the Cruze. I am going to install the KN air intake on my 1.8 and I need to disconnect the battery. I then need a security code after I hook the battery back up. Dealers charge money to reset the...

I would like to know what reprogramming steps are required after the battery on the 2012 Cruze has been disconnected and then reconnected. The 2012 owner's manual talks about needing to reprogram the power windows. Are there other areas of the vehicle that also need to be reprogrammed? I have...

My wife just bought a Chevy Cruze and backs into the garage everyday and really doesn't like the alarm going off the whole way. Thanks