Search Results for ‘drls’

I’m going to install an OEM fog light kit on my 2014 Eco pretty soon, but there’s one thing I’m a little unclear on. I’ve read on this forum somewhere that you can run the fog lights and park lights instead of the headlight DRLs. However, I’m in Canada where every car must have DRLs on whenever...

I’m thinking about putting a set of LED headlight bulbs in my 2014 Eco. However, I know that DRLs can pose a bit of a problem with LEDs due to the reduced voltage, would anyone be able to shed some light (excuse the pun) on any experience with LEDs in their Cruze with DRLs? Or if LEDs with the...

Hi guys and gals, I am a new member and I have a 2016 Cruze limited 2LT. I want to add the OEM style fog lights to compliment the LED strip DRLs. So what I'm wondering is are the part numbers listed below the right bezels and lamp for the non RS and how do I connect them to the wiring harness...

I purchased the LED DRLS kit with the switchback turn signals (turns from white to amber lights when turn signal is on). Problem is, I can't figure out wherected to connect on the car. I have a 2014 Diesel, does anyone have a wiring diagram they can provide or which wires control the turn...

Couple days ago the Winjet company came up with their new bright product. This time the guys wanted you to light up your way with their whole new black projector headlights equipped with daytime running lights for ultimate visibility. The headlights are manufactured from high quality materials...

I'd like to know if anyone has successfully disabled their DRLs. I thought I had read at one point that XtremeRevolution had done it, but I found the headlight harness thread and didnt see anything pertaining to the DRL function. I'm proficient at wiring and can do any mods needed, I just need...

So I got HIDs yesterday. I searched and read up on the ability to disable DRLs. Found the thread here and it looks like it's not possible. But, asking again in case someone has come up with something? Alternatively, as a work around, I know the DRLs work by sending a low voltage to the...

Was looking at getting a hid kit along with new projector headlamp assemblies. The drl system on the Canadian spec Cruze can't be turned off. I was looking at a hid kit from hidcanada that would have canbus digital ballasts and the tech support says they will work just fine as long as I just...

I recently bought these off ebay and despite my lack of electrical knowledge i decided to install them on my own by splicing them through the side indicators. I did this because my cruze didn't come with any factory fogs and i don't have a switch for the fogs. im happy with the way they look...

I fretted quite a while before installing these . They are thin side-emitter @.060" thick and 0.197" wide. The gap between the headlights on the vertical is, err Not enough. Poking old hard vacuum hose in almost was wide enough. Daylight output is good, night is not too bright. Night...

I'm getting ready to do my retrofitting project and I was want sure I have everything I need. I'm planning on ordering the BI-XENON MORIMOTO MINI STAGE III KIT (H1) from trs but I know I'll need some sort of harness such as the one ZZP sells - ZZPerformance - HID Relay Harness #ZZ-HIDRLYHNS-G2...

I just bought and installed an HID kit for my cruze but as others have noted the DRLs just flicker and then turn off now. Is there any way to either make the DRLs work with the HIDs or just turn off the DRLs completely? I know I can just turn the lights off during the day but I would much...

just thinking out loud, but when installing hids for the headlights, im certain that there is no more low watt high beam drl. the bcm still sends out the power for the high beams at low watt which now goes to the relay harness, which without signal from the low beams still wont turn on the hids...

Ok guys will start out and say hi so "hi" lol i just bought a hid kit for this car and of course there is a minor set back. The high beams are being voltage contralled by the BCM to produce drl's so in effort to not kill my ballast i need to know if anyone has been able to disable or...