Chevrolet Cruze Forums banner

gauge

  1. Gen2 Appearance, Body, Detailing, & Interior
    Let me know what you think. It took several hours to get it done very carefully, and to make sure it looks really good and not shoddy. Sent from my iPhone using Tapatalk
  2. Gen2 Appearance, Body, Detailing, & Interior
    Anyone know where to get a decent set of gauge pods for 2017 LT RS Hatch? I just tuned and would like a boost gauge and oil pressure at least. Not finding anything decently fitted, and never put these gauges in anything but a snowmobile, so not even sure where to look. Google only found stuff...
  3. General Discussion
    I have a 2012 LTZ 1.4 turbo and don’t pretend to know a lot about cars. But I was putting air in my tires today and was watching on the interior vehicle information screen, it was corresponding with the location of the tire I was actually filling. (Example: I was filling the L front tire and the...
  4. Cruze Parts
    I have a few parts left over from my 2012 Cruze project that was totaled by a careless driver on New Year’s Eve : / I prefer to ship to continental US only but willing to quote w/Canada buyers carrier of choice. ZZP Catless midpipe brand new in unopened box $160 shipped. (This will throw an...
  5. Gen1 1.8L
    Here's a short video of my cruze's temp gauge. This is the very first time the ignition is switched on. Any ideas what could cause this? When I last ran the car the previous night the temp was stuck in the red, the fan was blowing but the car ran fine once it had started but the warning bleeper...
  6. Gen1 1.8L
    Hi there. My temp gauge reads 1/4 when the ignition only is switched on first thing and the engine is reluctant to start. Once it starts it runs fine. This has happened a few times now. On the motorway it has started showing 2 notches below red and the fan comes on but the engine is cool...
  7. Gen2 Powertrain
    A month ago my temp gauge started reading 1/4 when the ignition was switched on (no engine started yet). The car was difficult to start but started eventually. After this it ran fine. After it had done this a couple of times the 'engine emission' light came on (little orange engine). I had the...
  8. Gen1 Diesel Technical Discussion
    Hi, just curious what people are seeing on their temperature gauge once warmed up and driving? Typically the needle should always be about 12:00 is the old school guideline. (or I guess 6:00 on these, right?) Mine seems to be stopping quite a bit short of that. about 8-7:00. (1/4 - 2/3) I...
  9. General Discussion
    Hi, my 12 Cruze, 1.4L auto, is reading very low on the temp gauge. Problem started with CEL P0496, then got the “high engine temp ac off” message. The temp gauge then started staying at the bottom. I changed the vapor canister purge valve and that cleared the code, but not the message. I...
  10. Cruze Parts
    The gauge cluster was pulled out of a car in the junkyard, the plastic lens and surround are in perfect shape just dusty from sitting, i have no idea if the gauge works or what the mileage would be. asking 30$ shipped. z/28 Camaro suede steering wheel bolts right in for 1st gen cruzes. steering...
  11. Gen1 Diesel Technical Discussion
    So I've got about 6k miles on my Cruze since I bought it a few months ago. I bought it from a salvage yard because it was involved in a rear collision with a secondary front collision and I know vehicles typically sit for a while at the auction yards too. When I first got the car running I had...
  12. General Discussion
    I used to drive a 2006 SS Cobalt Supercharged. Back when I owned the car I swapped the stock boost gauge out for one from Defi. I sold the car some 7-8 years ago, but I found my stock boost gauge. Would this be compatible with the 2011 1.4l cruze? If so could someone tell me what I would need...
  13. General Discussion
    Been looking around for a gauge to monitor everything. Has anyone used this gauge before? Considering it to save the hassle of running the plumbing for a mechanical gauge.
  14. Gen1 Service Issues
    Ac not blowing cold, fans not running at a low speed, cheapo ac gauge reads in “alert 2011 Cruze 1.4 has 106k on it, it has had the ac replaced and other bits along with it replaced in the past cause the ac ate itself (replaced 70k) It was super hot today (98 degrees) and the ac wouldn’t blow...
  15. Gen1 Appearance, Body, Detailing, & Interior
    Does anybody know if there’s a way to tap into a circuit that dims with the headlights on a 2014 Cruze Eco, so that a boost gauge could be dimmed at night? Thanks in advance, Sent from my iPhone using Tapatalk
  16. Gen1 Appearance, Body, Detailing, & Interior
    I’m going to be installing a boost gauge in my 2014 Eco next week, but I’ve got one question regarding mounting the gauge on the dashboard. The gauge will be mounted on top of the dashboard using a pod, probably by the A-pillar tweeter on the driver side. My question is, would there be a way to...
  17. Gen2 Diesel General Discussion
    I am trying to see if anyone knows of any Scangauge Xgauge parameters we can program in? The ones listed on their website for "any 2014+ Cruze diesel" do not work. I am figuring they haven't updated it since the 2nd gen has come out. Here's a link to the ones I couldn't get to work. I would...
  18. Gen2 Powertrain
    Hey guys, Is there a gauge holder/mount for our cars other than a piller pod? I would like to install a boost/vacuum gauge but I do not know where I could mount it. Side Window Piller has an air bag , correct? 2018 1.4 Thank you.
  19. Gen2 Powertrain
    I used an Ultragauge in my ‘12 Eco. Now in my ‘17 Gen2 the boost only goes to 3psi. I saw where someone said to change settings in TorquesApp to read correctly. Anyone know how to make the Ultragauge work?
  20. General Discussion
    Whats up guys, What do you guys think of the new gauge pod?
Top