Chevrolet Cruze Forums banner

jacking

  1. Gen1 Wheels, Tires, Brakes, & Suspension
    Hello all, After doing some research on here, I couldn't come up with a conclusion as to whether or not it is safe to jack the car between the two jacking points on the pinch weld. I am trying to put all four jack stands in the jack points to lift my 15 LT RS. I tried going a few inches off...
  2. CruzeTalk New Member Introductions
    Does anyone know the lifting points for a floor jack or hoist on a 2017 gen2 Cruze LS ? .There should be two at each corner. One for the floor jack, and a second for the safety stand. The rear axle beam is too high up between the battery compartment and the trunk spare tire well, to be of any...
  3. Gen1 Wheels, Tires, Brakes, & Suspension
    On my 3 previous VW Jettas use of a floor jack had caused at least one mutilated jacking point on each Jetta. Make a "jacking pad" from a 4" piece of 3 X 1 1/2 channel iron and a 4" piece of pine 2X3. Trim the sides of the pine to fit the channel, then glue the pine into the channel iron and...
  4. General Discussion
    Anybody have an answer? How to jack and lift my Cruze Not too much room underneath THANKS [email protected]
  5. General Discussion
    Guys, I know some gm cars have jacking points on the control arms or under the carriage besides the welded joints in the corners. Does our car have any?? I am contemplating on buying the uni-body jack adapter but want to make sure we dont have other jack points. thanks!
  6. Gen1 Appearance/Body Tutorials
    Finally had some time to install the $16.00 Mud Flaps today. This thread will cover 2 items. 1.Installation of the flaps 2.Jacking up the car and having it on stands for all 4 wheels. First thing. When I ordered them, I really couldn't tell from the pictures how big they were. I had...
  7. Gen1 Powertrain
    Where do you place a floor jack on the Cruze to raise the car. I would also like to raise the entire car to rotate the tires. Is there a picture somewhere showing the jacking points.
Top