Chevrolet Cruze Forums banner
lamp
1-19 of 25 Results
  1. Gen2 Service Issues
    My 2016 GEN2 Cruze has 9005 bulbs in the headlight. I noticed the 2017's use 9012 bulbs which are supposed to be better ( H.I.R. bulbs instead of standard halogen bulbs). It looks like the 9012's will fit in the 2016 headlamp socket, and if not, the tabs on the bulb can be trimmed so they...
  2. Lighting
    Are there parts available to install lights into the lower bumper? 2013 Cruze 1LT Sent from my SM-G930W8 using Tapatalk
  3. Gen1 Service Issues
    A little concerned tonight as the Malfunction Indicator Lamp is on & the engine is running a little rough. It was extremely cold last night, well below freezing but the car drove fine most of the day. Then late tonight the lamp came on. Could the cold be a factor? What does this lamp usually...
  4. General Discussion
    Hey folks, the title of this post says it all. What happened was i was driving on the interstate heading home, and some idiot in a F-150 ran over a semi tire and it flew up in the air and landed on the right side of the hood of my car. When it finally fell off my hood, it went underneath the...
  5. Lighting
    We just purchased a 2015 Cruze LT and one of the lamps below the headlamps are burned out. I can't figure out how to replace it. It's the one circled in the pic below. Appreciate the help!
  6. Cruze Parts
    comes with wiring harness for the h8 bulbs and i will include a set of h8 6000k hid bulbs and ballastys they are also brand new the foglamp assembly u see is the protective covering on the lens only reason why i am selling is becasuse the 15 cruze is completely different these even have the hole...
  7. Lighting
    Well I just purchased a fog kit for my Cruze. I figured you guys could use the part number breakdown for every part in the kit. The possibilities here are that you could buy a cheap Ebay fog kit but order the switch and harness for a better integration. Fog, Kit...
  8. Gen1 Service Issues
    Hello there, Yesterday as i started the car i noticed that the ESP lamp has turned on, i turned the car off then on again and it was still there, i went to work and when i arrived there i turned the car off then on again and the indication was gone! As i left work the indication was still...
  9. Gen1 Audio & Electronics
    I noticed a while back that my windshield washer did not work. I assumed it was just out of fluid, but today I got a "Check front left turn signal" DIC message, and sure enough the signal was out. I got some replacement bulbs and a jug of washer fluid, and opened my hood to discover that the...
  10. Cruze Owner Projects
    I dont want to use a spray on. Can someone suggest a film/vinyl ??
  11. General Discussion
    I was looking change the license plate lamps to LEDs today and when I went to remove the clear lamp covers, I noticed that BOTH covers had condensation behind them. I haven't removed them yet, decided to wait until I go to the dealer on Tuesday for an oil change and have them look at it...
  12. Cruze Owner Projects
    am i that stupid? I want to put LEDS in the reverse bulbs and I cannot get out the tail lamps?? i removed the 2 screws for each lamp and owners manual states to just pull straight back to remove. Well I tried for over an hour and cannot get them to pull out. Its HARD ENOUGH TO GET A GRIP ON THEM...
  13. General Discussion
    !00% more brightness to me is twice as bright, but any review I have read, more like 25%, any honest experience with these on this board? Second factor is life, some claimed only 2-3 months, not very good for a pair of bulbs where my local Carquest store wants $49.99 a pair. Home Depot, 40...
  14. General Discussion
    Hello, sometime over the holidays someone decided to what it looks like boot in my right side fog light. The black housing around it seems to be fine, but the actual light part seem to be really loose. The bulb of course burst, but the glass seems to have no damage to it. There also a small...
  15. Gen1 Appearance, Body, Detailing, & Interior
    http://www.ebay.ca/itm/140800199262?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649#ht_12765wt_1002 Just got these tail lamps and I'm trying to wire up the trunk mounted LED bars. Has anyone done an install on these? I tapped into the red wire on the brake light harness and the LED bars...
  16. Gen1 Appearance, Body, Detailing, & Interior
    So I'm going to say it. I HATE the tail lights on our cars. I think they are too big and bulbous. I would tint them but I really like the bright red, I've had too many tickets for black tails, and I don't want to put emphasis on how big the lights are by blacking them. So I found these half...
  17. General Discussion
    One of the more expensive parts to change when adding fogs, so my curiosity got the best of me what's missing besides that fog lamp silk screen on that center knob. Finger nail job to snap it apart, yes it still works after being snapped together. First surprise was that the PC lands for the...
  18. Lighting
    How do you install a fog lamp switch for a car wo fog lamps if you buy fog lamps. I have an LS and am considering the upgrade. Do you just buy a new headlight switch and install(like aftermarket Cruise control) or is there more wiring to be done?
  19. Lighting
    Hello guys, I really wanted those DRL in place of fog lamps, but wouldnt wanted to lose my Fog lamps but now i saw this fog lamp fascia with the DRL strip in the bottom i am absolutely i need of this so before i buy it what do you guys think ? any of you guys have this ? free shipping...
1-19 of 25 Results
Top