Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Gen2 Powertrain
    Daughter said CEL came on and engine was sluggish (limp mode?) AutoZone OBD showed code P0101 - Mass Airflow Sensor. Secondary codes... P1101 - Intake airflow system performance P0299 - Engine Underboost P2227 - Barometric Pressure sensor performance I changed the Air Filter and replaced the...
  2. General Discussion
    So if u look at my last post about my po171 code problem u will understand this post.. so today I took out the Bosch o2 sensor I put in last month with original Gm acdelos. Now my fuel trim numbers were high especially my long tirm fuel trim. Now I went and looked a my MAF sensor reading and it...
  3. General Discussion
    I have a 2016 Chevy Cruze lt that seems to be giving me more and more problems. check engine light had been on for a while and throwing the code p1101 only, so I replaced the MAf sensor, and cleared the code (or so I thought). Engine light still illuminated and it was still giving the same...
  4. General Discussion
    Hey everyone, I’m fairly new to actually making posts but I’ve had some questions lately so here goes. I’ve been working a lot on my Chevy Cruze 1.4l 2013, and there’s a lot of stuff that I got told about on a full vehicle inspection, I’ve researched most of and I’m working on it all right now...
  5. Gen1 1.4L Turbo
    Info: 2013 Chevrolet Cruze LTZ RS: 1.4 Turbo 120,000 miles Dorman Valve Cover installed PCV Fix Kit V3 installed Problem: Check engine light is on, rough idle, and the only code showing is P0102, I have replaced and done many things on the engine and the code still showing and MAF reading is...
  6. Gen2 Powertrain
    Hello! so I got P1101 code (which is code fore MAF sensor) replaced MAF did reset.. code came back 15 miles later... did smoke pressure test and did not notice any leaks. anyone experienced same issue ? suggestions ?
  7. Gen2 Powertrain
    Hello, i am new to the forums and was hoping to find some help on this subject. I have a 2018 Cruze with the 1.4L and manual trans. it is a daily driver but i wanted to do some intake upgrades and the position of the MAF sensor is making that a bit difficult. could anyone give me some tips on...
1-7 of 7 Results
Top