Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. Gen1 Audio, Electronics & Electrical
    Just got my minidsp installed and loaded the Xtreme's tune file from the SQ thread. Still getting familiar with the plugin and wanted to know what the input gain and output gain levels on the minidsp should be set to. Should they be at 0 or a negative number?
  2. Gen1 Audio, Electronics & Electrical
    Hey everyone, So i have taken the time to read through most of the tutorials and information on this site and on the miniDSP site, but i am having trouble truly wrapping my head around how this will actually integrate into my system. My build (for what will apply to the miniDSP installation) is...
  3. Gen1 Audio, Electronics & Electrical
    Hi everyone! I´ve recently bought a MiniDSP 2x4 (RevA) and a MiniDC but I need your advice to get the best sound of my configuration. I have the following equipment: - 4 channel AMP (Blaupunkt EMA 455) - 2 front speakers + tweets / 2 rear speakers + tweets (Blaupunkt Blue Magic CX 170 3 Ohm)...
  4. Gen1 Audio, Electronics & Electrical
    hey guys, browsed the site for an answer and couldn't find it. What PAC wiring harness do I need to connect the Minidsp to the radio?? What else would I need? I noticed that the minidsp had 4 out, which is find for my 4ch amp but what about my mono amp??? thanks guys! Ralph
  5. Gen1 Audio, Electronics & Electrical
    Okay guys, when receiving the MINIDSP and DC Isolator the instructions dont say how to connect the Isolator to the DSP. It does however give you a simple wiring diagram. After studying it for a while I found out you actually need to add an 18 gauge/ 2 conductor wire in between them to get power...
  6. Gen1 Audio, Electronics & Electrical
    I obv need some sort of adapter to connect the rca cables to the fac radio. What did you guys buy to do this??
  7. Gen1 Audio, Electronics & Electrical
    Where did you mount it?? In trunk with amps? Center console? Glove box?? Mine is coming in next week
  8. Gen1 Audio, Electronics & Electrical
    Hi everyone! As suggested in this forum, I bought a MiniDSP which is arriving next week! I was thinking about the audio line with this, which is going to have two equalizers (stock and minidsp), so: - What are your recommendations for the stock equalizer settings? Should I throw down the stock...
  9. Gen1 Audio, Electronics & Electrical
    XtremeRevolution helped design me a budget stereo system and also built me a bad ass box and front door baffles. He also went above and beyond with providing tech support during the tuning process. Here's a quick breakdown of what I'm running: -Vifa tweeters -Silver Flute Mids -2 10"...
  10. Gen1 Audio, Electronics & Electrical
    I'm going to start wiring up my new system this weekend, and the instructions for the Pac LOC are garbage, and the minidsp instructions are somewhat better but not by much. For the LOC, which wires do I tap into for power and ground? Should I buy a "add a circuit" for the #6 slot on the fuse...
  11. Gen1 Audio, Electronics & Electrical
    For those of you who have a MiniDSP in their Cruze, has anyone used a blank project box and mounted it in the trunk, or are most just making it fit behind the dash? I figured it would look clean if I could mount it in a nice box on the underside of the package tray, and just run the USB cable...
  12. Gen1 Audio/Electrical Tutorials
    Edit: This thread is obsolete. The thread remains for historical purposes. Refer to the SQ Car Audio V2 thread: This is going to be the mother of all SQ car audio threads. In this thread, I'm going to...
1-12 of 12 Results