Chevrolet Cruze Forums banner

needed

  1. Gen1 Wheels, Tires, Brakes, & Suspension
    Just put 20" kmc rockstars with 235/35/20 on my 2014 ltz and want to order the eibach pro kit. Was wondering when I take it to get a front wheel alignment do I need to purchase the camber bolts to keep my factory stance or is there enough adjustment in the stock.
  2. Gen1 Service Issues
    I bought my 2014 Chevy Cruze Eco brand new back in April 2014. Since then, I have had to jump it 4 times. About 12 months after I bought my car, the battery died and my car started acting like it was possesed. The key was locked in the ignition, the wipers were going non-stop and spraying...
  3. CruzeTalk New Member Introductions
    Hey everyone, I've got a 2015 Cruze LT1 that I'm looking to do some performance upgrades to and wanted the opinions of others first. What I'm thinking first is getting a tuner. I'm looking at the Advantage + by Trifecta... Yay? Nay? Thoughts? TRIFECTA - 2011+ Chevrolet Cruze - 1.4L Turbo...
  4. CruzeTalk New Member Introductions
    Mice have eaten thru the wires leading to my radiator coolant sensor (passenger side). 2013 Cruze ECO. i can't find the source of the two wires. Anyone have or can someone take a pic of the wiring leading to the Radiant Coolant Sensor? Much appreciated. Thanks
  5. Gen1 Audio & Electronics
    I just recently installed a single 12" SQ HDS312 my Cruze and I gotta say I'm super glad I took a chance with this brand! This 1200w sub pounds so hard even when I only have 900w pushing it! (Super impressed) but now I have one problem....vibration rattles in the trunk! :/ My rear corner panels...
  6. Gen1 Audio & Electronics
    Is anybody able to help with ECU pinout diagram for 2011 (or any later year) 1.4 litre turbo engine? I need to identify pins for revs, roads speed, TPS and clutch switch. Australian dealers do not want to help. Thanks.
  7. Gen1 Powertrain
    Here is my setup..in my 1.8 LS Stock manifold - stock down pipe 2.5" pipe in place of secondary cat> 2.5" pipe to a Vibrant resonator> 2.5" pipe to exhaust tip So I have no secondary cat and only a performance resonator. As I suspected, it sounds too ricey around 3k and I need to tone it down...
  8. CruzeTalk New Member Introductions
    My son (17) is about ready to ditch a 2002 Vw Jetta that has been killing us !! A dealer is offering us a 2011 Cruze...I think it's a 1LT. Thoughts? Does it have bluetooth. I have been researching this car all night and can;t figure out what it has and what it doesn't??
  9. Gen1 1.8L
    Hi there. I saw ZZP has 1.8 headers for a decent price. Most info out there is for 1.4t header installs. I have custom exhaust from the cat back, just a simple vibrant resonator and downturned pipe, 2.5" If I get the headers, what cat convertor will I need? I see the metal spun cats on zzp...
  10. General Discussion
    I am looking for another vendor that sells 2011+ Chevrolet Cruze 1.8L 4-2-1 Header and Catless Downpipe besides Bad News Racing because they are out of stock.
  11. Gen1 1.8L
    Hi all Ive got my cruze to be scanned because of a misfires and shakes with the engine and low performence ... The car shakes and stops even when its on D so the results are attached in the image ... Reset the car computer and only the first and the second result stayed ... So where is the place...
  12. Gen1 Service Issues
    I’m enjoying my 2014 Cruze. I’m curious what experience people have had with alignment. According to the Cruze owner manual, the Cruze is properly aligned at the factory and requires no adjustment unless you hit something. How true is that? I’ve read reports that a lot of cars are out of...
  13. Gen1 Service Issues
    Hi i bought my cruze about 5 weeks age the car is used for sure so ... Ill cut to the chast of this topic ... 1-the car wont start in cold mornings after try to start it for 5_7times i works . 2- the car burns fuel like a crazy ass and there is a lose of power . 3- ive noticed some rough idle...
  14. General Discussion
    2.0 turbo diesel in the USA. I have been getting the water in fuel message. At 14,000 the dealer Says i need a new fuel filter. I thought there was a drain on the filter that needs to get emptied to drain the water out at oil change intervals. Otherwise i can get a new filter for $78. Dealer...
  15. Gen1 Wheels, Tires, Brakes, & Suspension
    Hey guys so I am thinking about getting these 17 Milanni wheels for my Cruze Eco 17" x7 Milanni Bel Air 5 MI459GB Black 5x105 5x115 38 Et 459 7795GB38 Rims Whee | eBay and am wondering about the best size tire option to go with. I want a low profile look but am concerned about decreased mpg...
  16. General Discussion
    I just got word from my dealership that they need to replace the entire engine! I took it in because the "engine" light was on. They diagnosed it as something to do with fuel flow and air flow.... whatever... They did a bit of work and sent me home. That night there was a puddle of oil on the...
  17. General Discussion
    Hey guys, so last week I prepared my vehicle for the new elite trifecta flash, I took out my plugs and gapped them at .028 as well took off my stock blow of valve and put on the forge atmos BOV. After all that, I move onto flashing my Cruze with the new tune. I drove it and it drove like it...
  18. General Discussion
    I recently tried to do the cleaning of the trunk button to get it to work again, didn't work because the button was corroded beyond repair. As mentioned in previous post, the replacement but (in the form of the button/switch and lisence plate light) an be purchased. It was also mentioned in...
  19. Gen1 1.4L Turbo
    First post here and my apologies if this has been asked before (wifes car so somehow my fault.) Anyways it has a coolant leak. Ive found the source of the leak but have been unable to locate the part (Have only been looking onli e to no avail so far.) My best guess is this is where the overflow...
  20. Gen1 1.4L Turbo
    Working on putting this engine in a Lotus Seven race car frame and could use some preliminary dimensions of the engine. I cannot find them anywhere on line. I need: Height: from bottom of oil sump to top of valve cover Height: Center of crank pulley to top of valve cover Length: from...
Top