Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 8 Results
  1. Gen1 Service Issues
    Does anyone know the exact size of the o-ring on the coolant hose? For the life of me I cannot get the hose to seal correctly where it connects to the water outlet... It's constantly leaking, and when I put a bigger one in there I guess it was an AC one and it didn't handle the heat I guess...
  2. Gen1 Powertrain
    I discovered a coolant leak from the connector that connects one of the heater core coolant supply lines. It has an o-ring inside of it that has deteriorated. Could some Me please tell me the size of the o-ring needed? The part is no. 6 on diagram.
  3. Gen1 Service Issues
    When Sherri and I arrived in Youngstown yesterday she said my car smelled hot. This isn't normal so I popped the hood to see a very thin sheen of oil across the top of the engine. Today at the Lordstown Park after our plant tour we were looking at it and one of the guys pulled the dip stick...
  4. General Discussion
    Just drain the oil and noticed the O'Ring was gone, found it under the Cruze, wasn't broken or anything, looked in good shape, but never fell off before. So I cleaned it and used a bit of RTV just in the groove to hold it back on. Occurred to me, always replacing the O'Ring with a new filter...
  5. Gen1 1.4L Turbo
    So ive noticed a pool of oil start to accumulate below the turbo oil line. I have used a qtip to remove and clean the oil in the area and over the course of about 1k miles it will eventually return and pool. There really arent many other places I can think of in the area to cause this leak and I...
  6. Gen1 1.4L Turbo
    I have a 2012 Cruze 1.4l with automatic trans. I installed a forge bov the other day then took it off to compare the difference between it and the stock bpv. I happened to noticed that the inner o-ring on the forge bov broke in half. Part of it was still on the bov and the other half was in...
1-6 of 8 Results
Top