Chevrolet Cruze Forums banner
p0302
1-9 of 9 Results
  1. Gen1 1.4L Turbo
    I have a 2015 Chevy Cruze Ltz. The car has about 130,000 miles on it but had a new engine installed around 79,000 miles. The car has been putting out an error code for a year for the evap syetem and hasn’t given me really any issues. I got gas Sunday and as soon as I fired it up I knew something...
  2. Gen1 Service Issues
    This car is running fine now
  3. Gen1 1.4L Turbo
    2014 Cruze 1.4L: 76k , all orig besides tune Brand new NGK BKR7E Gapped at .028 New Ignition Coil (Delphi) Throttle Body cleaned Intake PCV bypass done Cam cover replaced twice, about 1.5 years ago, bolts were checked at 79in lbs of torque. Also checked vaccuum distribution for leaks Need help...
  4. Gen1 1.4L Turbo
    Hey guys, hope all is well. 1.4L Turbo New plugs (NGK) and coil 10k miles ago 72k on orig motor Car bucked hard lastnight on highway and display litup like a xmas tree. P0302 #2 mis fire. I pulled plugs, they all looked good but gap opened up to about .030. I closed up the gap to .025 while I...
  5. Gen1 Service Issues
    Hey guys, Was hoping I could get some insight on this before investigating any further. I'm in PA where the weather is obviously very bipolar. Back in February I was driving up a relatively steep hill at about 15 mph and it sounded like the engine was hesitating to run. The engine light blinked...
  6. Gen2 Powertrain
    cyl #2 misfire -- says bad piston = new engine, in the shop a few weeks (got a loaner) It took 24K for this problem to show. Anybody know if the warranty on the new engine will be 36K or just the balance?? Also is the new engine new or rebuilt? -- probably should have asked the dealer :uhh:
  7. Gen2 Powertrain
    23,640 miles on a 2016 gen 2 - no previous issues - but over past week it runs rough, showing lousy gas mileage, now showing P0302 -cyl 2 misfire and stabilitrack malfunction (which I think just comes with a misfire) should be under warranty - have scheduled an appointment with the dealer...
  8. Gen1 Powertrain
    The other day when my wife came out from work and started the Cruze she pulled out of the parking lot and within a half mile the MIL started flashing and the service stabilitrack message came on. After a bout 30 seconds everything came back to normal, no lights or warnings and the car was...
  9. Gen1 Service Issues
    Today I went and got a car wash and shortly after service stabilitrak and service traction control poped up and has code P0302 stored. Now the car is running terrible has anyone else had this happen?
1-9 of 9 Results
Top