Chevrolet Cruze Forums banner
p1101
1-20 of 47 Results
  1. General Discussion
    I have a 2016 Chevy Cruze lt that seems to be giving me more and more problems. check engine light had been on for a while and throwing the code p1101 only, so I replaced the MAf sensor, and cleared the code (or so I thought). Engine light still illuminated and it was still giving the same...
  2. Gen1 1.4L Turbo
    Hello all, I hope you're well. After my initial post (Chevrolet Cruze Possible ECM Malfunction), I replaced my battery, spark-plugs, and coil pack. I ordered a new valve cover and valve cover gasket, but only changed the gasket on the original valve cover since I did not notice any visible...
  3. Gen1 Service Issues
    Hi all, I am new to this form and was wondering if anyone has experienced this before. About a week ago my 2014 1.4L Cruze was idling rough, lack of power, etc and throwing out codes: P0106, P0171 and P1101. I took it to my local Chevy dealer and they replaced the intake manifold and the valve...
  4. Gen1 Service Issues
    Hi all, I recently had the turbo replaced on my 2012 SRi-V 6sp auto. It actually wasn't the bypass valve being stuck open - it was the turbine itself being completely wallered out and not spinning due to the turbo oil feed line clogging up with bits of a failed filter. That was a fun $2k+ job...
  5. Gen1 Powertrain
    Check engine light came on this morning, took it to autozone and in this order codes read P0171 System too lean (bank 1), P0106 Manifold Absolute Pressure/BARO Sensor Range/Performance, P1101 Intake Air Flow System Performance, Autozone recommendation is to replace fuel injector. But knowing...
  6. General Discussion
    Check engine light is solid (never flashing). I only had p0101 being thrown at me so I replaced the mass airflow sensor & the air filter (which was disgusting) & Now I keep getting the codes: P0299 p0101 p1101 Anyone know what is throwing all 3 codes out?!
  7. Gen2 Powertrain
    Hello! so I got P1101 code (which is code fore MAF sensor) replaced MAF did reset.. code came back 15 miles later... did smoke pressure test and did not notice any leaks. anyone experienced same issue ? suggestions ?
  8. Gen1 1.4L Turbo
    ok so my cruze has had the p1101 on for about 2 months now but today it and p0171, p0507 showed up and idle goes up and down in rpm. any ideas?
  9. Gen1 Service Issues
    Hi All, New to the forum. A friend of mine has a 2013 Chevy Cruze (1.4L) with the following codes: P0171: System Too Lean (Bank 1) P015B: O2 sensor Delayed Response - Lean to Rich Bank 1 Sensor 1 P1101: Intake Air Flow System Performance P2270: O2 Sensor Signal Stuck Lean - Bank 1\, Sensor 2...
  10. Gen1 Service Issues
    P0106, P0171 & P1100 - Surging at idle. *FIXED* So I fixed my boost leak bought a couple new parts, did my serpentine belt. Fired the car up and it's been idling very rough. Took it for a drive and it has it's power back but when idling it surges and the car jolts back and forth. The CEL came...
  11. Gen1 1.4L Turbo
    So as the title states, I installed a cold air intake today (one of the longer ones, previously had a short ram) and now I was almost immediately met with a P1101 code. At the same time I also did installed a BNR (Forge) atmospheric bypass valve. There were no codes before the install...
  12. Gen1 Service Issues
    So after reading a bunch of forums and watching a lot of videos, I decided that a straight pipe from the second cat back would be a good choice so that my car could breathe more and it hopefully wouldn’t cause back pressure problems, for about a day everything was fine and now at red lights my...
  13. Gen1 Service Issues
    Hello everyone. My 2014 Cruze LT has been throwing code p1101. The mileage as of now is 90k. In winter of 2017 I took it to dealership due to another issue that resulted in the pcv manifold being replaced (the diaphragm had a leak). I’ve read that a vacuum leak can throw this code and many of...
  14. Gen2 Service Issues
    What should the MAF sensor be reading at 700 rpm?
  15. Gen1 Service Issues
    I have a 2014 chevy cruze with 70,000km on it I'm getting a p1101 code. I've tried cleaning the mass airflow sensor but that didn't fix the problem. Any idea if this fix would be covered under warranty if they either need to replace the sensor, fix the wiring, or if there is a leak in the...
  16. Gen1 Service Issues
    Hello, new to this cruze forum.check engine light wont go away. I recently replaced valve cover and it is running alot smoother, however the code still keeps coming out and I need to smog it asap. It did populate something about the traction control before I replaced the valve cover. Anyone else...
  17. Gen1 Service Issues
    My check engine light turned on and I had taken it to two different autozones where they checked my CEL and it gave them the code P1101 for my MAF. I replaced it after about 3 weeks and while I hadn’t replaced it my car would idle up & down when I have my ac on high, like if my engine was trying...
  18. Gen1 Powertrain
    Hey Everyone - Got a 2011 Cruze LT 1.4l turbo A/T, 141,xxx miles on the clock, owned since new. Recently replaced the valve cover (typical PCV issue). Yesterday upon first start-up of the day the engine starts misfiring badly, with the car's CEL starting to flash, and good ol' "Service...
  19. Gen1 Powertrain
    Hey everyone I'm new to this forum and not 100% sure if this is the correct spot to put this post so mods if you see this please move it. I just recently got this car from a friend that co-signed it for someone else they ended up doing quite a bit of damage to it so I'm fixing it up myself and...
  20. Gen2 Powertrain
    Hey everyone I'm new to this forum and not 100% sure if this is the correct spot to put this post so mods if you see this please move it. I just recently got this car from a friend that co-signed it for someone else they ended up doing quite a bit of damage to it so I'm fixing it up myself and...
1-20 of 47 Results
Top