Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

21-40 of 49 Results
  1. Gen1 Powertrain
    Hey everyone I'm new to this forum and not 100% sure if this is the correct spot to put this post so mods if you see this please move it. I just recently got this car from a friend that co-signed it for someone else they ended up doing quite a bit of damage to it so I'm fixing it up myself and...
  2. Gen2 Powertrain
    Hey everyone I'm new to this forum and not 100% sure if this is the correct spot to put this post so mods if you see this please move it. I just recently got this car from a friend that co-signed it for someone else they ended up doing quite a bit of damage to it so I'm fixing it up myself and...
  3. General Discussion
    I had the check engine light come on so I brought it to AutoZone to see what it was. It was the MAF air flow senser so I bought some cleaner, I'm tried this twice and then decided to buy a new one which I got at Rock Auto for 40 bucks. After installing the new one the light still was there so I...
  4. CruzeTalk New Member Introductions
    Hey everyone! I'm new on the forum, I decided I needed help from some fellow Cruze owners. I have a 2013 Chevy Cruze 1.4T MT. The issue I'm having is a P1101 code being thrown I've replaced the PCV tube and cleaned my MAF sensor and the PCV on the valve cover is not leaking. The issue started...
  5. General Discussion
    Hello All, I got in the car this morning and my CEL came on. I ran my code reader on it and got p0106 p0171 p1101 p0131 b2aaa. It idles very rough and is slow to take off. It stutters a bit until second gear. i have 52k miles on it. the only thing i have done is put a K&N air filter on it. That...
  6. Gen1 Service Issues
    2011 Cruze 1.4L Eco 6 Speed Manual About a year and a half ago, I had the well-known issue with these codes being thrown, and had the valve cover replaced. The start of that journey is here...
  7. Gen1 Service Issues
    I previously sent a PM to XR but I decided to post it on here as well due to the extra codes. So a week ago I got a CEL p1101. I checked all the hoses and they all seemed fine. I've been sick so I never did clean the MAF sensor. I cleared. The codes and then yesterday I got a p0171 and 2635...
  8. Gen1 Service Issues
    Installed new ebay intake and got those 2 codes runs like a turd now. Reset the ecu before install. Used a honeycomb insert in intake. I reset the ecu and put the stock back on and the power was back and no codes. Whats up with the intake?
  9. Gen1 Service Issues
    (new, I hope this is the right subforum, if not please let me know) Bought a 2013 Cruze about 6 months ago, been running great until a few weeks ago I would have problems starting the car and I would need a boost to start it, then it'll start fine for a few days, then boost and repeat. I took...
  10. Gen1 Powertrain
    I have a 2012 1.8L that is throwing those error codes. I have read so many different takes on how to resolve them, but nothing seems to directly answer my questions. On some of the other threads, other posters have asked if the owner has a K&M air filter in relation to those codes, but no one...
  11. CruzeTalk New Member Introductions
    Currently trying to figure out the code reasoning for P1101. I have replaced the MAF sensor and put in a new air filter, replaced the coil pack, an O2 sensor and the gasket on my motor, put new transmission fluid in it and an oil change.. The problem started as it would start sputtering when...
  12. Gen1 Powertrain
    I took my 2013 eco (1.4l turbo) into the dealer last week for a CEL. They replaced an evap solenoid for $220 labor plus $30 for the part, unfortunately not under the power train warranty (I'm at 94000). The light came back a couple days later. I've tried cleaning the MAF and checked the pins...
  13. Gen1 Powertrain
    Ok, so I took my belt off to check the water pump and found out it is bad. Put it all back together only to find out I have 2 codes. P0106 and P1101 To be honest, it's my wife's car and I can't say with 100% certainty that the light was not on before. I did notice that it has a rough idle...
  14. Gen1 Powertrain
    I have a 2011 LT with 87K (out of warranty). There are no mods. I've been researching my issue and have read the TSB on the P1101 code that I can't get to go away. In the past I have replaced the valve cover (PCV issue) and the PCV isn't venting so that seems OK. I took a shot in the dark and...
  15. Gen1 Service Issues
    Drove the wifes car tonight and after about 7 miles I noticed a rough idle and the service stabilitrac & traction control off lights came on. Got home and scanned the car. P0106 & P1101? Also, squealing noise coming from the belt side of the engine. I have noticed a wet spot in the driveway...
  16. CruzeTalk New Member Introductions
    Hi I'm new to this forum and I have a 2011 Chevy Cruze LTZ. Just hit 100000 miles I've had it for 2 years now and it's been nothing but a mess. My latest problem is the CEL keeps coming on and it's p1101. I've already put a new MAF and a new valve cover/pcv on and the light keeps coming back...
  17. General Discussion
    A month ago bumper removed and my 2011 eco threw the engine code for fuel pump control module. I replaced with a non eco module, problem solved. Now am getting the codes listed above in that order. With these code combinations, does it still sound like a bad valve cover? It must be related to...
  18. Gen1 Service Issues
    I have the following codes on my Chevy Cruze Codes P0507, P1101, P0171, P0106, P015b I also have a recall on the vehicle and was wondering if the issue with the recall could be causing the codes. Also if the issue with the codes are covered under the powertrain warranty. Any info on the codes...
  19. Gen1 Service Issues
    Hello all! There are some other threads that partially deal with the issues I am having, but none seem to be an exact match, so here I am. 2011 Cruze Eco 6 speed. I bought it 3 years or so ago as Certified PreOwned. Currently 74k miles. I developed a coolant leak a few months ago. Traced...
  20. Gen1 1.4L Turbo
    To get it turned off: New seals for oil dipstick, new seal for oil fill cap, cleaned MAF sensor with CRC MAF sensor cleaner, cleaned throttle body with CFC throttle body cleaner, put in new air cleaner. I don't know which one did it, but CEL now off. Dealer wanted 500 dollars to do this and...
21-40 of 49 Results
Top