Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. General Discussion
    Hello my name Corey and my 2013 Chevy Cruze 1.4 turbo it has 103000 miles on it just had the valve cover replaced at 100,000 miles but the car has me stumped. I have several codes P0097 sensor 2 circuit low bank 1, P0113 sensor 1 circuit high, P11C2, and P2227 barometric pressure circuit range/...
  2. Gen1 Powertrain
    Recently replaced the turbo because the maniford had substantial cracks were the waste gate valve sits. After loosing all power on the interstate. Looking for good advice. Car will start for about a second or two and die.
  3. Gen1 1.4L Turbo
    Hi all, It seems as though one thing leads to another. I just installed the PVC fix , to fix the PO299 boost leak code, ( V2 kit) , a new valve cover, plugs, and a coil ( contacts corroded) I drove the car aprox 500 miles, and all the sudden, the PO299 code shows up again. Found a leak...
  4. Gen1 1.4L Turbo
    Hi Guys, my 1.4L turbo has some new problems that I'm hoping you can help me with. On a recent road trip the check engine light came on after a few hours of driving and I noticed reduced power, especially on starting from stop and on uphills. Felt as if the turbo boost wasn't working. Once we...
  5. Gen1 1.4L Turbo
    Could have sworn I put it all back together correctly! About 300 miles after rebuilding the Oil Cooler I got a CEL indicating all the above codes (enhanced mode). Basic code was P0299. No leaks, ran great. Actually still seems to run fine! Any input would be greatly appreciated.
  6. Gen1 Powertrain
    Hey all fellow Cruzers! Hoping I can find some info and or guidance with my issue. I have a 2014 1 LT with 123K miles. About a week ago I got a P2227 with a pending P0234. I did some forum searching and even a post on FB CruzeTalk that suggested a new MAP sensor, got that. I was due for...
  7. Gen1 1.4L Turbo
    Can somebody help me located this barometric pressure sensor?
  8. Gen1 1.4L Turbo
    So I just put a diablosport intune tuner on my Cruze and am running the diablotune "93" tune. When driving it and merging on to the highway it was pulling great then all of a sudden the car fell on its face. No engine light came on until I let the car sit for a few minutes and restarted it. I...
1-8 of 8 Results