Chevrolet Cruze Forums banner

pedal

  1. Gen1 Powertrain
    I drive a 2014 1LT manual Cruze, I got the clutch fluid changes at 45k miles. Soon after I was making a 4 hour drive and halfway through I needed to change gears but the clutch pedal went to the floor, and the clutch was still engaged. Once the car cooled down again the clutch began to work...
  2. General Discussion
    My 2015 Cruze gets really hot by my right leg/gas pedal while driving. The wall, only on the driver side gets hot, but not every time? It sometimes gets so hot, in the summer when I get out of my car with sandals on, the heat can get pretty intense from under my car. Any ideas what it could...
  3. Cruze Parts
    Looking for the above parts as I drive my 2018 Auto trans with two feet. Basically, the whole Set Up. Tnx G
  4. Gen1 Service Issues
    Hello Friends... MY daughter has a 2011 cruze 6 speed manual. The clutch pedal goes down with almost no effort.....and then wont go into gear. The fluid level is fine, no signs of leakage anywhere of fluid. My daughter said a while ago (yes daughter is a little light on the details) that...
  5. Gen2 Appearance, Body, Detailing, & Interior
    I'm looking for a set of pedal covers that will widen the gas and / or brake pedals. I can't heel-toe with this setup. Seems most of the "universal" setups are designed for short accelerator setups, whereas we have long "gas" pedals. What have you got, and do you have photos? Thanks...
  6. Gen1 Powertrain
    i have owned alot of cars and all of them have went faster when pressing the pedal more... not this one... lol how can i fix this?
  7. Gen1 Diesel General Discussion
    Has anyone tried the Pedal Commander on their CTD? If so, did it make any difference or is it just hype?
  8. General Discussion
    So, when driving in a traffic jam, I feel like I constantly need to lift my foot up. It never feels balanced. The brakes too, I feel so little resistance in pushing the pedal to where the brakes start gripping. Is there a way to adjust a spring setting, or make it feel heavier (meaning, needing...
  9. Gen2 Powertrain
    Has anybody that has floored their Cruze feel the accelerator pedal stop, but if you keep pushing down it will go down a little more? I'm not sure if this is by design or if something is wrong. Thanks!
  10. Gen1 Service Issues
    So, I just dropped my car off [2014 Cruze LT] for the 3rd clutch spring (and other associated parts) to be replaced. The last one snapped in the parking lot of the dealer when I went to pick the car up. They replaced the first spring under bumper to bumper. The last time they charged me for...
  11. Gen1 Diesel Technical Discussion
    Hi All, Bought the Cruze Diesel back in July 2013 and have thoroughly enjoyed this car thus far. Got about 130K on it now, just changed brakes for first time!About a week after changing brakes, I started noticing a single click or pop noise coming from the engine compartment whenever the gas...
  12. Gen2 Appearance, Body, Detailing, & Interior
    At highway speeds, my 2016 (gen 2) Cruze has an annoying rattle that comes from the area of the parking brake pedal. This happens most often when going over bumps and uneven pavement. It's very frequent and it telegraphs up through the dashboard. If I lean the side of my foot agains the...
  13. Gen1 1.4L Turbo
    So, after I changed my clutch (failed DMF. Changed with OEM GMPP clutch kit and OEM throwout/slave) at 105k miles, it drove fine when driving normally, and you could press the clutch at any speed, but if you released the clutch too fast, the clutch would stay disengaged (i.e. like it was pushed...
  14. Gen1 Wheels, Tires, Brakes, & Suspension
    I found instructions to perform a Brake Pedal Position Sensor Calibration. Calibration Procedure Apply the parking brake. Ignition ON, engine OFF, place the transmission in the PARK position for automatic transmission or NEUTRAL position for manual transmission. Install a scan tool. Clear all...
  15. General Discussion
    I have a 2013 Cruze lt turbo with a cai and a trifecta tune and I just ordered the pedal commander off Amazon.Has anyone else tried the pc with a trifecta tune?the company says it will work with any tune.The trifecta tune does help with the pedal lag but there's still some lag and I've seen...
  16. Gen2 Service Issues
    Hi, i only have 5000 km and when i try to shift, my clutch pedal stick at the bottom ( maybe its not the good word) and it take 2 sec to reach my feet when i release it. the dealer changed a master cylinder, the problem is still here but they said ''maybe it could place by itself''... maybe...
  17. Gen2 Appearance, Body, Detailing, & Interior
    I have a 2016 Gen 2 Cruze that I purchased new. The very first time I set the parking brake, the cheap rubber pedal cover twisted and broke apart. See attached pic. Has this happened to anyone else? Very disappointing to see such a cheap piece on an otherwise great car.
  18. Gen1 Wheels, Tires, Brakes, & Suspension
    So I haven't had my '14 Cruze for 2 months (stupid deer...) and I haven't been driving a Cruze at all for the length of time. I can't recall how the brake pedal is supposed to feel. To me, it feels really soft. Is it supposed to be soft or should I have it checked out?
  19. Gen1 1.4L Turbo
    Just received another letter from GM. "SOME 2012 MODEL YEAR CHEVROLET CRUZE VEHICLES MAY HAVE A CONDITION WHERE THE ACCELERATOR PEDAL CAN BREAK AT THE STALK JUST BELOW THE HOUSING DUE TO THE DRIVER ENTERING OR EXITING THE VEHICLE WITH THEIR FOOT RESTING ON THE PEDAL." How nice of them to...
  20. Gen1 Service Issues
    Hi to all. This is my first post here and I hope you can help me. I am owner of chevy cruze ls, 1.6, 113hp, 90 000 km. Recently I have replaced main clutch cylinder. Brakes worked ok. No sound from brake pedal. Afterwards I had to replace rear brake pads. After all these fixes when I push...
Top