Chevrolet Cruze Forums banner
pressure
1-19 of 124 Results
Advanced
  1. Gen1 Service Issues
    Hey guys, I did my first own oil change on my 2012 Cruze Ls 1.8 and am now getting a oil pressure low message. The cars making a clicking sound when running. I checked the oil pressure and it seems fine. I went through and made sure all parts were secured, and they still are. I was...
  2. Gen1 1.4L Turbo
    Just wondering if anyone has a cut-away of the 1.4T's oil gallery/passages, I suspect I have some sealant caught in the passage to the head, causing the lifters to click. I've replaced the lifters, the old ones looked fine (None of them were collapsed, there goes $200!), also used compressed...
  3. Gen1 Diesel General Discussion
    I'm hearing a whirling/whining sound after engine shut down for about 15 seconds. From what I've read here, it's probably the Fuel Rail Pressure Control Valve. Does this sound means it's getting time to replace or is it normal. It just started doing this a few weeks ago. We have around 150K on...
  4. General Discussion
    Just purchased a great looking car for my daughter and the tire light is on, along with Service system Message on dash. I took to tire shop and they told me not reading the sensors, that my computer needs reprogram. The tires are original 32K miles on them, all holding air 32-37psi. Will the...
  5. General Discussion
    I drove a good 70 miles yesterday, some in stop and go traffic, probably 2 - 2.5 hours total. Yhe low pressure light still hasn't gone out and the screen still shows the low pressure for all 4 tires. They are supposed to reset automatically right?
  6. Gen1 Service Issues
    Can't Re-learn Tire Pressure Over the weekend I finally changed over to my Winter Tires and now I cannot relearn my TPMS. It was working when I took of the 18" Rims and when I changed it to the 16" Winter tires the display said to relearn the TPMS. I bought this tool on Amazon.ca...
  7. Gen1 Wheels, Tires, Brakes, & Suspension
    I own a 2013 Cruze LTZ, and since I live in Canada it does not have the Tire Pressure Monitor System in it (I have gone through every possible menu, trust me it does not have it). Obviously, there are four radio frequency transmitting pressure sensors (one for each tire), I could easily get...
  8. Gen1 1.4L Turbo
    So my 2013 Chevy Cruze LTZ W/107,000 miles very recently started losing oil(1 quart over 6 months) and coolant as well as idling very poorly. And most recently the oil dipstick has had ALOT of negative pressure on it to the point if I pull it out it doesn't stutter and then quickly bounce back...
  9. Gen1 Wheels, Tires, Brakes, & Suspension
    Thinking about getting a set of rims for winter wheels and have some questions about what tire pressure monitoring sensors to get and how to program/relearn. 1. OEM vs. Aftermarket sensors - Anyone have experience with the sensors that Belle Tire (or similar) sells/installs? Do they utilize...
  10. Gen1 1.4L Turbo
    I have a 2012 1.4T auto with 119000 miles. I am getting positive pressure out of the valve cover @ idle. I believe this is causing the oil leak I have. The car only leaks under load, and most of the expelled oil is located low on the passenger side of the engine compartment. I am going to do...
  11. Gen1 Wheels, Tires, Brakes, & Suspension
    I just bought some nice snow tires on rims for my 2015 Cruze. It doesn't have TPS in the rims, just standard valves. Guy said the light will be on in the dash. I know my wife will make a stink over this in her new car. I priced out sensors and I figure $200 out of my pocket....Question is, is...
  12. Gen2 Service Issues
    Hi, I was hoping someone could give me some advice. I have a 2016 Chevy Cruze and went and got the oil changed today. Well after my oil change the message low oil pressure stop engine came on. It only come on when I am not moving. I took it back to valvoline and they did another oil change...
  13. Gen2 Powertrain
    Hi guys, I installed a boost/vacuum gauge to see what the stock boost pressure is. On average I see about 12-14 PSi range maybe it can get to 15 PSI in certain conditions. Just curious if that seems about normal? For the vacuum side with the engine idling I see about 10-11 inches, does that...
  14. Gen1 Audio & Electronics
    I have a 2014 Chevy Cruze diesel and for quite a while I have been getting error messages about the TPMS system and also security messages and the key fob no longer works. I am not certain but I think this may have started around the time I replacedd the windshield. My understanding is that the...
  15. Gen1 Wheels, Tires, Brakes, & Suspension
    On our data screen one can find a readout on the tire pressure. I love it. The problem is that it seems not to be accurate anymore. My passenger front tire reads as being two lbs below what it actually is. I've checked them and they are all at 37 lbs according to my manual gauge. But when...
  16. Gen1 1.4L Turbo
    Hi guys. Replaced my rocker cover thinking that I may have a PCV related fault (rough idling), but no significant change... I have a negative pressure on the filter cap now and also the dipstick. If they were like this before I changed the rocker cover then it wasn't as noticeable. I used the...
  17. Gen1 1.4L Turbo
    Not sure whether this has been posted before, but does anyone know the spec of the crimp that is on the plug for the oil pressure sensor (nect to oil filter)? Mine is missing. Thanks in advance.
  18. Gen1 Powertrain
    2015 cruze. Just changed the oil pressure sensor on the front of block.. didn't stop the error on display.. or this beeping. Is there a 2nd sensor?? Help! I have oil.. no leaks..
  19. Gen2 Wheels, Tires, Brakes, & Suspension
    My 2018 Cruze the tires are filled with nitrogen or so they say. What I have been reading, is that the tire pressure should not fluctuate with nitrogen. Is that true? It doesn't appear to be the case for me. I've noted (with the sensors on the car), that I can go from 240 kPa to 265 if...
1-19 of 124 Results
Top