Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 13 Results
  1. Gen1 Service Issues
    Hello. A few days ago I started my car and it was very rough. It started fine the rest of the weekend. This morning the engine light came on when I started the car to go to work. I just had this problem in January of this year. This problem has happened 3 times now. Is there anything that could...
  2. Gen1 1.4L Turbo
    Hi all, i have a 2012 Cruze Eco 6 MT with just over 100K. i'm getting check engine light with code P0496. i found great basic info here searching the error code & it sounds like either part in question can reasonably fail at this mileage but what's not clear is how to tell whether the purge...
  3. Gen1 Service Issues
    There seem to be two distinct sources of "ticking" noises from my 2015 2LT AT, 67k miles. The louder of the two sources I have determined is the purge valve solenoid behind the engine. I've read differing accounts on whether this is normal for the purge valve, and many reports where replacing...
  4. Gen1 1.4L Turbo
    I've had my cruze since October 2017. It's a 2011 LT RS. After a year of driving, the CEL pops on. Nothing out of the ordinary as far as driving but I brought it in right away to have it check out. It does have a powertrain warranty so I hoped it was covered. The codes were a Lean and Evap code...
  5. Gen1 Service Issues
    I put on an intake the other day. I was very careful not to bend/break anything. It was a cheap one. I did everything right. No power at all and no check engine light. I decided to look into it today and upon driving around, I could hear a loud hiss like it was leaking under boost, I could...
  6. Gen1 1.4L Turbo
    I have a 2013 Cruze. The purge valve has been diagnosed as bad, causing the engine to run lean. The dealer is saying the purge valve is not covered under the 100,000 mile powertrain warranty or emissions warranty. Can you tell me why a part of the powertrain would not be covered under the...
  7. Gen1 1.4L Turbo
    I've been hearing what I thought was noisy injectors, coming from my engine bay for a while now. I was finally determined to figure out why my Cruze was so much louder than the rest. Found it to be the Evap purge solenoid, mounted to the intake maniold. Once the car is warmed up, and the...
  8. Gen1 Powertrain
    Purge valve replacement clears (5) OBD codes My wife's 2012 Cruze LS(?) with Ecotech had a few issues: hard starting after gas fill-up sometimes erratic idle Stabile-trac warning on dash appearing often After doing some online (thanks to those who posted) research and talking to...
  9. Gen1 1.4L Turbo
    I have been getting an obd code that points to this. In reading some of the posts some say it's in the engine bay and other that it by the fuel tank. This is for an 11 Cruze Eco. If it in the engine bay I'd tackle it, but living at an apartment complex hard to work under the car. Any tricky...
  10. 👋 CruzeTalk New Member Introductions
    I need to know where the purge solenoid valve is located.
  11. Gen1 Service Issues
    Hello, I am trying to solve a pesky check engine light and I believe I have it narrowed down to the purge solenoid valve. It seems to be a common problem on these cars, and I am trying to repair the fault on my own. However by searching on the Internet I haven't been able to narrow down a...
  12. Gen1 Powertrain
    my check engine light came on about a week ago (fyi there is a fuse that can just be pulled to turn off check engine light #52 if like me you find annoying till the problem is fixed) it read p0443 purge control valve 3 times. i changed the part and cleared light, however on second start the...
1-12 of 13 Results
Top