Search Results for ‘relay’

My cruze is throwing many codes and idk why. Boost sensor, o2 sensor, IAT sensor, throttle actuator sensor and some more. The revs bounce at idle and stop after a minute. I can't see any vacuum leaks. A few times now the car has said engine power reduced and wouldn't accelerate and then just...

Hello. 2011 Cruze 170k km Gas Codes: P0171, P0299 21,000$ rebuild at 140k km due to deer hitting it Just bought it cheap. Looking for reasons as to why my cooling fan is dead. Fuses seem good? Ones corroded slightly but good internally. Not equipped to check relays. Fan spins freely by...

My wife has a 2011 Cruze LT 1.4L Turbo. Her front passenger blinker went out. I replaced the bulb and got a day or two out of it but it's now not working again. When using the right blinker, it flashes rapidly and only the rear light functions; the front does not light up. Upon inspecting the...

After returning to my car with the trunk wide open too many times I decided to take the the internet and see if anything could be done. Turns out it's a common issue and the double shot relay is the remedy, you know the rest of the story, I'm sure. Installing the new relay was easy enough...

OK 2011 Cruze non turbo USA Cooling fan was not working at all. It looks like someone has also replaced the compressor. Gauges indicate 105 psi on the low and high, so there is gas in it but compressor does not create pressure differential (appears to be a clutchless compressor). A/C snowflake...

Cannot find anything in the manual. Is it bcm or is there a relay somewhere that I can't find? Sent from my LG-H918 using Tapatalk

Good afternoon everyone,　 I am looking for the fuel pump relay on a 2012 Cruze LS with the 1.8L engine. I see theres a spot in engine compartment fuse box that lists the relay but theres not one there.　 Can someone one tell me where its at? 　 Thanks

When I switch on the high beams-nothing glows-no highs, lows, or fogs. On low beam, lows & fogs work. There is no power under both high beam fuses #37 & #38 in checking them, but both are good. My Question is where is the high beam relay in the engine compartment fuse block-what number is it?

This says it all: Forgive the slight blur, too lazy to did out my good camera. In testing both relays, the OE gives a tiny click when energized, this one has more like a clunk, solenoid current is exactly the same at about 125 ma. Using my best ohmmeter, contact resistance is 0.000001 ohms...

Contacts are of a silver alloy, coil resistance is 80 ohms paralleled by a 680 ohm 1/4 resistor for some weak form of inductive flyback protection. Contact resistance was high, can't view this in the photo, but the contacts for both the armature and the fixed contact had a ring of carbon around...

This is how to install the 2nd shot trunk relay: I know there is another thread about this but tonight I installed the relay and it is easy once you know exactly what to do and this is how it is done. 1) after buying a 2nd shot relay( I found mine on Ebay for $60 part # 19119267) Can buy...

the horn relay I can not find it...and I need to see it to be sure of the location....I have problems in these two elements thank you

according to the diagram is in the box under bonnet..... but can not find please help..!!!

Saw this while looking for something else, but I bet nearly every dealer will miss it if the problem comes up. If a '14 Cruze has the two shot trunk release fix and the BCM gets reloaded, the trunk will not open with the FOB. The relay has to be changed back to the single shot relay. I know...

I purchased a double shot trunk relay for my 2012 Cruze about a month ago, paying around 80 dollars from my local dealer. It did not fix the issue I was having with my trunk so I am putting the relay up for sale for anybody looking for one. I had it in the car for about a week. The black plastic...

I've searched the forums, and can't find any info. Anyone know the TSB number for this? I want to talk to my dealer about it in the morning. Thanks. Sent from my Droid Ultra

Well guys took the cruze in for the two shot realy only to find out its on back order but there going to call me when they get one in

Hey guys, I recently ordered an RGB Led Strip, 5 Bosch type relays, an add-a-fuse and a 10m rgb extension cable, I want them to turn on with the instrument panel lighting or with the dome light (pretty much an OR logic gate), but since I'm a noob regarding this I need some help. 1) Is there any...

hey guys, so if anyone has been following my buld thread ( a bit not updated right now ) i have been working on a LED bow tie. the one i bought kept breaking so i made one myself from scratch. SO THE ISSUE i have blue LEDs and red LEDs. the blue will be runners while the red will be brake...

Techno Guru's With the 2012 SRi-V or I guess LTZ equivalent I have two distinct relay ormechanical switching sounds that can be heard under the steering column, onlywhen accelerating through 20KPH or 12 MPH after engine start. If you stop attraffic lights or stop signs during that drive, the...