Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

41-59 of 124 Results
  1. General Discussion
    I need to know if anyone has replaced the side impact airbag sensor that is located in front of the RR wheel? I found the sensor after removing the bottom of the rear seat and plastic trim piece on the outside of the RR seat airbag. The trouble is that the fastener head is located closest to...
  2. Gen1 Brakes/Suspension Tutorials
    How-To: Replace Sway/Anti-Roll Bar End Links Overview: The factory sway bar (aka anti-roll bar) end links are made of plastic and tend to get worn after a while, which causes rattling heard in the front end of the vehicle. In addition, they have an excessive amount of flex, being made of...
  3. General Discussion
    I may have to replace my engine. Does anybody here any experience with this? May have blown headgasket which is quite pricey. I see an engine with 22K miles for 1000.00 and may be cheaper than the HG issue. I have 130K on mine. Been great up to now.... was hoping to get at least 200k out of...
  4. Gen1 Appearance, Body, Detailing, & Interior
    Is there any way to replace the stock shift knob with one that has lights on the numbers and R? I really want to add that extra glow at night or in the dark from my shift knob.
  5. General Discussion
    I know a whining manual transmission has been an issue some other people have experienced and have had troubles getting dealers to fix. Here's how I handled it. Hopefully this experience helps some other people having this issue. I bought my Cruze Eco with a manual transmission certified used...
  6. Gen1 Engine/Transmission Tutorials
    How-To: Replace CPASV (Camshaft Position Actuator Solenoid Valve) Seals Overview: Yes, I needed to make up an acronym for this one. Moving forward, let's just refer to them as CPASV seals. I found these seeping on my 2012 Cruze at 58,000 miles when I noticed a slight oil loss (about 4oz in...
  7. Gen1 Diesel Technical Discussion
    Having just gone through the RVC problems I make reference to a earlier 2011 post on how a properly functioning Cruze system should perform, particular to the post by n4435rc ...
  8. Lighting
    Hello, I am having issues where the brake light will remain on intermittently after pressing and releasing the brake pedal. Once the car warms up it will start doing it more and will happen every time I press and release the brake pedal.when this happens, to make the brake lights turn off I...
  9. Gen1 Diesel Technical Discussion
    Wound up kinda confused. So I get the trim piece out of the car and see this: The trunk switch is covered with some sort of epoxy. Can't for the life of me get it out, the sealant is rock hard. Every reference online says that shouldn't be there. So I run to the Chevy dealership to see...
  10. Gen1 Service Issues
    Sorry, but the radio buttons don't work well. My MP3 usb stick loads fine on the radio, but fast forward or rewinding does not work well. The FF/REW function for some reason always gets interrupted, no matter how hard I press the button, and if I apply constant (heavy) pressure on the button, or...
  11. Gen1 Audio, Electronics & Electrical
    Is there a way to replace the infotainment screen on the Cruze or remove it all together and put storage in its place? It is a 2011 LT and out of warranty. The screen must've gone bad at some point, and just always shows "Elapsed Time 0:00" now. Took it to the shop, they told me it is...
  12. General Discussion
    Hi all. I have Cruze 1.6 (2011) and i swapped the steering wheel with one that has cruise control on it. I connected all together and the cruise control didn't work ( no light on dashboard or nothing) I took it to the dealership and he plug it to the bcm and programmed to have cruise...
  13. General Discussion
    Hi all. I have Cruze 1.6 (2011) and i swapped the steering wheel with one that has cruise control on it. I connected all together and the cruise control didn't work ( no light on dashboard or nothing) I took it to the dealership and he plug it to the bcm and programmed to have cruise control...
  14. Gen1 Audio/Electrical Tutorials
    Here's a step by step tutorial on how to change your foglight globe. This was done on my 2012 Holden Sri Cruze
  15. Gen1 Diesel Technical Discussion
    I have a 2014 cruze diesel, I broke off a front wheel stud while hand torqueing my wheels to 100 ft/lbs (mystery) anyway, I found the thread on grinding the back of the new stud to slide it in without the bearing removal. I haven't tried this yet as I had to order one, but I was wondering...
  16. CruzeTalk New Member Introductions
    Hi, so I drive a 2012 Cruze and my car got broken into today. They broke my passenger side rear vent/quarter window to get in. I called the shops and it cost about 350 to replace it and since I am a poor student, I don't have that kind of money. So i have found the part online but I was...
  17. Gen1 Diesel How-To & DIY Library
    The repair for NOX Sensor #2 is identical to the replacement instructions for the Particulate Matter Sensor with the following amendments: 1. NOX2 is the forward of the two sensor bodies. 2. The sensor module for NOX2 is to the rear of the Fuel Filter (as opposed to the module for the...
  18. General Discussion
    Anyone ever seen this before? Wife just had PCV/valve cover replaced, get the car back and the DIC keeps saying replace the remote battery 0%, got the other remote, same thing! Car is a 2012 LTZ, so, I went and replaced both batteries, same sh_t!! Called the dealer, service guy says they have...
  19. General Discussion
    I know the Cruze and Camaro brands are in two different classes but the new 2016 Camaro is opening its hood to a 2.0 turbo-four at 275HP. The V6 Camaro is just 60HP more. It's bold, but amazing move on Chevy's part. We all know we've been wanting a Cruze with more power and I just think this is...
41-59 of 124 Results
Top