Chevrolet Cruze Forums banner
rpm
21-40 of 84 Results
  1. General Discussion
    This morning I got in my Cruze and it started sputtered and died, I started it again and the dash lit up, service stablitrack, CEL, car would not rev above 1100-1200 RPM and kept stalling out, I pulled the negative cable and after it started and ran but is shifting really rough, any advice?
  2. Gen1 Service Issues
    What troubles me is another problem: Drive the car for a while Press clutch and break (for example on red light, doesn't need to be fast breaking) Engine RPM will be dropping below Idle and jumping up and down between 500-900 This will continue until A: Car stops moving (brake can still be...
  3. Gen1 Powertrain
    Hi All, I have 2014 Cruze Equip (auto transmission) Australian model. Rev needle is moving up and down by 50-100 rpm on idle (regardless of which gear selected. Mileage is 46000km. I took it to dealer and after 4 days later they told me that for this age and mileage it is normal. Yeah but I...
  4. General Discussion
    I am an owner of a 2011 Chevy Cruze RS with Turbo 1.4L. I just had my turbo charger replaced last week at around 71,000 miles and received my car back this week. On my daily commute I travel on a 70MPH highway and use my cruise control for the duration of the drive. I don't 100% remember where...
  5. Gen1 Diesel Technical Discussion
    DPFDP, What is yours running at idle and 1500 rpm on a flat? DPF Differential Pressure Im at 0.0 - 0.1 on idle and 0.1 - 0.2 at 1500 rpm. Im just curious. Thanks if you add some info much appreciated.
  6. Gen1 Service Issues
    Driving home from the airport last Monday I had to downshift to pass an idiot who decided to pull up next to me and sit there. I slowed down - he slowed down. I sped up - he sped up. Once I was at 75 he dropped back. In third gear this puts me close to 5,000 RPM and my car started to misfire...
  7. Gen1 Service Issues
    Hey All, We just recently traded our '12 Cruze 2LT for a '16 Cruze Limited LTZ. With 6500 miles I am getting the engine lite blinking and service traction and service stable track warnings. Took into the dealer shop today and found a history of high rpm miss codes. They could not find the...
  8. General Discussion
    For you MT drivers out there, what RPM do you engage the clutch at when starting from a stop? Personally, I engage it around 1.5k, but have a friend who doesn't mind taking it up to 2-2.5k to have a smoother takeoff.
  9. Gen1 1.4L Turbo
    So let me try to explain my troubles... I got my 2011 Chevy Cruze LT 1.4 Turbo back in January of 2014, so I've had it a little over 2 years at this point. I originally wasn't going to get another chevy because of the problems I had with my 2003 Chevy Malibu (Anti-Theft System preventing me from...
  10. Gen1 1.4L Turbo
    when sitting at idle, in drive....what should the car idle at as far as RPM's ???
  11. General Discussion
    Hello guys, I dont have much knowledge about the car stuffs, but recently i have an issue in my car and no one could sort the problem. Occasionally my car RPM goes to zero at the time of driving or stand by and some times engine cut off. Once it is in standby then the engine cutt off but after...
  12. Gen1 Service Issues
    I have a 2012 cruze 1.4 manual. A while back I had an issue where the car would bounce rpms a little, and over time for progressively worse to where it wouldn't idle. I replaced the valve cover and it seemed to have fixed everything. But a couple months later I'm having the same issue, and now...
  13. Gen1 Diesel Technical Discussion
    2014 Cruze Diesel, 21xxx on the clock. Noticed this issue awhile back, not sure if it is common or "normal". Under light acceleration the RPMs drop anywhere from 50-400ish from the 2000 mark. It sounds as though it is shifting, but its not. Does not seem to bog down; although, sometimes it...
  14. General Discussion
    Heya guys! Fresh face here, reporting in. Ended up grabbing a new 2015 Cruze 1.4 Turbo 6 speed manual to get me to work throughout the winter months, and due to the fact that I've got a number of tools to carry (Millwright). Bit of a bummer in comparison to my motorcycle, but I made sure to get...
  15. Gen1 Service Issues
    Anyone have any idea what this noise is? Trifecta tune, Injen CAI. https://youtu.be/QtIDGhGclLk
  16. Gen1 1.8L
    i have chevy cruze 2011 1.8 l (i think manufactured in korea,in the middle east cruze comes from korea),when i am in a complete stop and the car on (D) and when i push on brakes the RPM fluctuates i feel the car is tended to go forward and then backward.I notice that the engine is tilting...
  17. General Discussion
    Hi, Hopes that someone can help me. I have a Chervrolet Cruze 2.0 LT diesel, it has gone +120.000 miles The last couple of weekes my car starts to hops/jumps a little, when i reach 1700-2300 rpm and drive in steady speed. When there comes a little hill, it runs like someone put gasoline in...
  18. Gen1 1.4L Turbo
    Hello All, I have had the Trifecta installed in my 2012 Eco 1.4 Turbo for about three months now. About two weeks ago I noticed a misfire above 4000RMP and it has been progressively getting worse. It got to the point where I had trouble merging and intentionally short-shifting to stay out of...
  19. Gen1 Powertrain
    Hey everyone! I have a 2014 LT manual with the 1.4T for what it's worth. I get what sounds like gears grinding whenever I shift from first to second at high RPM's/heavy acceleration. I know it isn't my technique as I am no noob to driving standard. It's only in this gear change and under high...
  20. General Discussion
    Hi guys, I have a 2011 Cruze with 45,000 miles. As far as I know, all the recall are caught up. Also, I have kept to the GM Maintenance schedule. The car runs great and there are no dash lights on, but my RPM at idle bounces around a few hundres rpms and feels rough. I bout to take it on a 2,000...
21-40 of 84 Results
Top