Chevrolet Cruze Forums banner
rpms
1-13 of 15 Results
  1. Gen2 Powertrain
    I drive a 2018 Chevy Cruze LT. I just replaced my Mass air flow sensor. My car seems to be reving at a higher than usual RPM when I accelerate (like merging onto the freeway not so much in city). It revs between 2500 and like 3250 and it just seems too high. I'm assuming I need a transmission...
  2. Gen1 Diesel Technical Discussion
    Trying to figure out this noise I'm hearing between 2500 to 3500 rpms mostly hear it in 1st and 2nd gears, been reading and looking online, figured I'd ask about it, any idea?
  3. Gen1 Service Issues
    Is it normal for my RPMS to operating/climbing slow as **** like it's struggling to build rpms in between gears? (I.e) shift to 2nd gear @ 3k drops to ~1200 then builds sslllllooowwwww struggleee etc..forced to give it even more gas
  4. Gen1 1.4L Turbo
    Sounds similar to this video here: https://www.youtube.com/watch?v=cXmptsHVP4s The sound itself sounds like its coming from the passenger side footwell but its definitely the engine. Sounds almost like it is buzzing. Is this normal?
  5. Gen1 Service Issues
    Hi, Not sure if this was previously talked about, but I have no idea what I would be searching for, so here I go. Last week, I had the valve and cover replaced according to the bulletin for the poor history of these parts. This would actually be the 2nd time this has been done. The first...
  6. Gen1 Diesel General Discussion
    What rpms are you at when it's at idle. I'm 800. Can't seem to achieve my old mpgs since new egr valve was put on. The outside temp has dropped to the 30s . so that does have a effect but I was getting 700 miles easily out of a tank all winter now its struggling to get there
  7. General Discussion
    I have a 2011 Cruze LS with 53k miles on it and up until yesterday hadn't had many complaints about it, with the exception of the number of recalls. Although the fan has been quite loud for a while now, every shop I take it into says they can't find anything wrong and that I shouldn't worry...
  8. General Discussion
    Has anyone heard a slight buzzing sound when accelerating at higher RPMs (5500ish). I have owned two Cruzes, a 2011 LS Auto, and now a 2014 1LT Auto and I just heard this for the first time a few days ago and again yesterday. The first time it happened, I was on the highway with my cruise...
  9. Gen1 Powertrain
    When sitting still idling in neutral, if I only press the clutch (no brake or throttle) the rpms will quickly blip from 700 to 850-900 for just a half second then fall back to 700 with the pedal now to the floor. Trying to figure out if this is normal with others... specifically if this is...
  10. General Discussion
    I get this little chirp or buzz when my needle passes 1,200 rpms on it's way down to idle. I was wondering if anyone has this. Sounds like some kind of heat shield vibration or resonance of some kind. Video starts with cold idle and every time the car hits 1,200 rpms after every rev you'll...
  11. Gen1 Powertrain
    I have a 2012 tuned Eco. I find if I am trying to run thru the gears and "speed shift" but not the no lift shift. When I push in the clutch and release the gas, the RPMs remain high. I don't know if it did this before tuning or not. I do not do this often, but strikes me as odd. If it is a...
  12. Gen1 1.4L Turbo
    2012 Chevrolet Cruze (US/Canada) | Cruze US/Canada Service Manual 2817 | Preliminary Information | Document ID: 2811496 #PI0715...
  13. General Discussion
    Hey guys, proud owner of a new cruze, loving it so far.... My one slight annoyance (and it might just be something I am not used to) is that I feel like in order to get remotely any sort of speed/acceleration from a stop, the RPMs get well above 3000 (and almost to 4000) in 1st and 2nd gear. If...
1-13 of 15 Results
Top