Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 203 Results
  1. Gen1 Service Issues
    Hoping to get some suggestions for troubleshooting. Recently had a P0599 code and noticed my radiator fan had stopped working because the ground cable wire from the fan had come off the bolt. Found a 6m x1 hex flange nut to secure ground cable and fan started working normally again. Code went...
  2. Gen1 1.4L Turbo
    This car is nothing but trouble. Had a coolant leak, replaced the housing, then the gasket on the housing blew. Got all that fixed and now today I started hearing a clicking or tinging noise. I had driven through some debri earlier in the day and it honestly sounded like something got sucked up...
  3. Gen2 Service Issues
    I have a 2018 Chevy Cruze. Base model. I've had nothing but problems with this car since I got it 6 months ago. I keep getting error codes like crazy. First I started getting turbo under boost codes, found a lot of water in the air pipes and pvc. Probably from frost and snow storms. Then I...
  4. Gen1 Service Issues
    I have a 2012 Chevy Cruze 1.4t that I just replaced the motor with a used motor because the head gasket went on the original one. I heard the motor run and scanned the computer and everything seemed good. I don’t think there’s anything wrong with that. Im having a reoccurring issue that started...
  5. General Discussion
    Bought a used 2011 Chevy Cruze 1.4 L4 eco manual. Bad idea I know. Scrolling through the Vehicle Information menu, I can see everything but the coolant temperature. Instead I get a black screen where the coolant temperature should be. Do I have to replace the temperature sensors to fix this?
  6. Gen1 1.4L Turbo
    So been having some issues with my 2014 Chevy Cruze 1.4l. Ben dealing with a check engine light that keeps coming on which previously was for the catalytic converter which I still haven't replaced yet. However now I'm getting this code: P0324 knock control system error From what I can tell...
  7. Gen1 1.8L
    Hey all, i’m trying to help my brother in law fix his 2012 Cruze. He’s getting the infamous “A/C disabled due to high engine temp” message. I replaced the temp sensor in the thermostat area and cleared the code...it worked for a couple of hours and then the code came back. So I figure it’s...
  8. General Discussion
    I have a 2015 cruze which I purchased last year. it had been damaged on the front end. 3 months into having it I noticed that when it rained or took it to the car wash the AC, would stop working for like for 8 hrs also the outside temperature display read -40. I took apart the front bumper and...
  9. Gen1 Powertrain
    New cruze owner (2011), tried a quick search to identify with no luck. I have not thoroughly searched the forums due to time crunch, if the info is already posted please point me in the right direction. Am I looking at the oil cooler sensor? Can I replace this without doing the whole wiring...
  10. General Discussion
    Hello Everyone! I am new to the forums and generally new to my Chevy Cruze. Purchased about 6 months ago, it was in a previous crash which most things were fixed other than the driver's airbag. It wasn't a major crash from what I know, though enough to deploy the one airbag. It is a 2013 Chevy...
  11. Gen1 Service Issues
    I've replaced it twice and neither sensor brand new is ohm'ing out. Both bought from different places. Is there a good place to get these sensors?
  12. Gen2 Powertrain
    Hello, i am new to the forums and was hoping to find some help on this subject. I have a 2018 Cruze with the 1.4L and manual trans. it is a daily driver but i wanted to do some intake upgrades and the position of the MAF sensor is making that a bit difficult. could anyone give me some tips on...
  13. Gen1 Diesel Technical Discussion
    Trying to find this sensor on the daughter’s 2014 Cruze Diesel. ACDELCO 55591401 COOLANT TEMPERATURE SENSOR goldcruzetempsensor The problem is that the temp gauge does not ever show any reading. We installed a ScanGauge-II, it reports 40 degrees at all times. So I bought the easy to find...
  14. Gen1 Diesel Technical Discussion
    I don't know, It looks perfectly fine to me ;) Thank you Torque APP and Rock Auto!
  15. Gen2 Service Issues
    Hey guys, I have a 2018 with a little less than 9,000 miles on it. My check engine light came on today so I stopped in at Auto Zone to run the diagnostics. Turns out it is my knock sensor. Just curious if they normally need replacing so soon. Also, could it cause anything else to need replacing...
  16. General Discussion
    Anyone know what the manufacturers warranty is on this.... The outside temperature always reads horribly off.... Point in case, right now it's 33 degrees, it reads 57
  17. General Discussion
    Hello- A few weeks ago, my 2011 LS stalled after turning over. It took several tries to get the engine to turnover and stay on after the first start/stall. Since it was during one of the Polar Vortex events we've had in Ohio, I thought it was simply the cold. This past Saturday, I had the same...
  18. General Discussion
    Hi there. I've all but fixed my 2016 Chevy Cruze limited 1lt after the front bumper was torn off in an accident. I can't seem to find the harness/pigtail to connect my new ambient air temp sensor back up. I believe that the sensor clips into the front left bumper/grille but as I stated I can't...
  19. Gen1 Diesel Technical Discussion
    I thought I read about this before here but I cannot find it. Almost directly above the oil drain bolt, there is a C clip with a sensor plug in. Not sure what that is but looks like possibly a oil level sensor. It appears to be leaking from there, is that a known issue on these? Is it covered...
  20. Gen2 Audio & Electronics
    Ive heard the Gen 1 blind spot sensors pretty much a 100% failure rate due to them not being adequately sealed from contaminants. Were the Gen 2 sensors redesigned or sealed better to avoid this problem?
1-20 of 203 Results
Top