Chevrolet Cruze Forums banner
snapped
1-5 of 6 Results
  1. Gen1 Appearance, Body, Detailing, & Interior
    So the other day my battery died, reasons unknown. but anyways when i tried to pop the hood, the release latch in the car snapped and broke the cable. my question is, how can i access under my hood? i have tried yanking on the snapped cable from the interior. no luck, it is super fking cold...
  2. Gen2 Service Issues
    I just picked up a 2017 LT/RS hatch and realized on the back bumper where the black plastic meets the paint has 2 or 3 clips not all the way in. It sticks out away from the body about 1/16th of an inch. I've tried pushing them in with no luck. See photo edited below. https://imgur.com/a/CuNPu...
  3. General Discussion
    So I was noticing in my car that on the passenger side the little tab to adjust the vent for the air was missing (must have snapped off). Are these tabs something you can purchase or am I going to have to replace the whole vent. Anyone else experiencing this?
  4. Gen1 1.4L Turbo
    So I was driving around yesterday when I heard a bang or knock type sound. As it became more frequent and louder I became alarmed and curious. So I went under the hood today and noticed right away that there was a bolt hole staring at me. Right next to it was a loose bolt. I wanted to see how...
  5. Gen1 Service Issues
    One of the wheel studs wasn't torquing down, so I kept loosening and tightening it with my clicker torque wrench. The stud decided it had enough, so it snapped at well less than the 100 ft/lbs the torque wrench was set to. :angry: All of the other studs torqued down fine and clicked at 100...
1-5 of 6 Results
Top