Chevrolet Cruze Forums banner
solenoid
1-18 of 18 Results
  1. Gen1 Powertrain
    2012 Cruze 1.8 liter engine. Transmission Solenoid malfunction. The car throw code while driving down interstate. Car drove for another 30 minutes without an issue until we could check the code. Can you replace the solenoid without replacing the transmission. I only $2500 on the car. Should I...
  2. Gen1 1.4L Turbo
    Hi all, i have a 2012 Cruze Eco 6 MT with just over 100K. i'm getting check engine light with code P0496. i found great basic info here searching the error code & it sounds like either part in question can reasonably fail at this mileage but what's not clear is how to tell whether the purge...
  3. Gen1 Service Issues
    There seem to be two distinct sources of "ticking" noises from my 2015 2LT AT, 67k miles. The louder of the two sources I have determined is the purge valve solenoid behind the engine. I've read differing accounts on whether this is normal for the purge valve, and many reports where replacing...
  4. Gen1 1.4L Turbo
    No vacuum leak was detected after filling engine with lots of smoke at 3 psi. Then why the low vacuum reading on the gauge? And why the high Long Term Fuel Trim? Perhaps ECM is advancing timing too much due to faulty data from one of sensor data streams the it uses to control camshaft position...
  5. Gen1 1.8L
    Hey All, I have a 12 LS and am looking to replace my variable valve timing solenoid(s) oil regulation / actuator. Does anybody have any info on replacing this? Seems the only thread on this is for the 1.4t which is different. So far I found part number ACDelco 55567050...
  6. Gen1 1.4L Turbo
    I've been following the thread on the P0496 error code which is either the purge valve or Solenoid valve. The first is easy to find in the engine bay and hopefully that will fix the problem. I not then it's the Solenoid Valve which is supposed to be somewhere by the fuel tank but it's very vague...
  7. Gen1 1.4L Turbo
    Hi I'm experiencing the following problem: Before starting the engine and just by turning key to ON position the wastegate solenoid next to the wastegate and under the turbo intake hose starts clicking hard. Here's a video of the sound. (don't be fooled the engine is off, it's just heard by...
  8. CruzeTalk New Member Introductions
    Hi, New to the forum. I've had the EVAP Vent Solenoid shorted twice in one year. Is this common?
  9. Gen1 Engine/Transmission Tutorials
    How-To: Replace CPASV (Camshaft Position Actuator Solenoid Valve) Seals Overview: Yes, I needed to make up an acronym for this one. Moving forward, let's just refer to them as CPASV seals. I found these seeping on my 2012 Cruze at 58,000 miles when I noticed a slight oil loss (about 4oz in...
  10. Gen1 1.8L
    Hello, My check engine light came on, I took it to Auto Zone and it was reading the code P011. They told me that I needed to replace the variable valve timing solenoid on the intake side. I have the part, but when looking at the engine, there are 2 solenoids. An intake and an exhaust. When...
  11. Gen1 1.4L Turbo
    I've been hearing what I thought was noisy injectors, coming from my engine bay for a while now. I was finally determined to figure out why my Cruze was so much louder than the rest. Found it to be the Evap purge solenoid, mounted to the intake maniold. Once the car is warmed up, and the...
  12. Gen1 Appearance, Body, Detailing, & Interior
    My '12 Eco's driver's door lock solenoid had grown weak to the point where the lock button had to be hit 2-3 times to get the door to lock. The solenoid is incorporated into the latch assembly and cost about $100 wholesale, but it can be found on eBay new for about $50. I replaced it last...
  13. Gen1 1.8L
    I could really use some help on this one. I have a 2011 Cruze with a 1.8 liter. I recently had my Cruze shipped to Hawaii and figured at 140k miles I'd drive it another year or two and trade it in or sell it. I'm on a pretty limited budget because moving to Hawaii is super expensive. My wife...
  14. Gen1 1.4L Turbo
    I have been getting an obd code that points to this. In reading some of the posts some say it's in the engine bay and other that it by the fuel tank. This is for an 11 Cruze Eco. If it in the engine bay I'd tackle it, but living at an apartment complex hard to work under the car. Any tricky...
  15. CruzeTalk New Member Introductions
    I need to know where the purge solenoid valve is located.
  16. Gen1 Service Issues
    Hello, I am trying to solve a pesky check engine light and I believe I have it narrowed down to the purge solenoid valve. It seems to be a common problem on these cars, and I am trying to repair the fault on my own. However by searching on the Internet I haven't been able to narrow down a...
  17. Gen1 1.4L Turbo
    Hello fellows, I’m a newbie here. The car is 2013 1.4LT automatic, all stock. I have recently noticed that BSV operated when it should not – when only ignition key is on and the engine is not running. I kept the ignition on for a longer while but BSV never stopped modulating. The car is...
  18. Gen1 Diesel General Discussion
    Alright, as mentioned all over the web about 2010-2011 cruze transmission problem; unfortunately I am one of them who is also suffering due to this; does replacing transmission solenoid solve the issue with transmission or not? Does anyone know part number for it as really I don't want to spend...
1-18 of 18 Results
Top