Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. General Discussion
    I have recently been trying to find some tail lights for my '12 Cruze and I saw on TikTok someone had clear sequential tail lights but I can't find anything except on ebay but a lot of the clear tail lights don't specify if they are sequentials. Anyone seen any before besides customs? I might be...
  2. Gen I
    I bought them brand new from lm performance. They work perfectly. I've only had them installed for a month. I just don't like the look now. I'm asking 225. Again in perfect condition. I take waaaay too good care of my car. Everything is included. Bulbs, all four light housings, etc. Please...
  3. Lighting
    I have a 2011 Chevy Cruze and my parking light in the front on the driver side and my rear running and brake light on the driver side are all not working. No power to any of them. I tested with volt meter. All fuses and relays good. Any ideas on what would cause this before I send it to the shop.
  4. Gen2 Audio & Electronics
    Hey all! First post here. I have a slight concern about my 18 Hatch tail light. I bought from Wal-Mart the 921 led bulbs to replace my stock reverse bulbs. Upon installation the current bulb base is wider then expected. On the stock reverse bulb it reads; W2W Ew 3KG M 27K13. Curious as to what...
  5. Gen1 Appearance, Body, Detailing, & Interior
    I was backing out of my driveway and didn't notice a garbage bin behind me. I suppose the entire tail light will have to be replaced as the plastic cover is non replaceable. Where can I buy an oem tail light for my 2015 cruze?
  6. Gen1 Appearance, Body, Detailing, & Interior
    LED Tail Light Install help Need Suggestions Purchased new BMW style tail lights off the internet. The inner ones are in just fine working and all. However, the wiring on the new BMW style outer lights do not match my 2012 LT. I am a bit confused because I was under the impression that these...
  7. Lighting
    Hello Everyone, I was wondering how to disassemble the tail light housing so I can pack them with LED's. I have the wiring all figured out I just need to figure out how to get the tail lights apart. Do you just put them in the oven like you do for headlight mods and what not? Any input would...
1-7 of 7 Results