Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 70 Results
  1. Gen 2 Tuning/Engine Modifications
    Greetings, Long story short I had the motor out so I could replace the clutch and during the reinstall I added my ported and polished throttle body. The car ran well for a few days without an updated tune but started to stall and die. Turned out I never tightened the ground wire on the...
  2. Gen1 1.4L Turbo
    Hey guys, I am rather new still, and lately (more like several months) been dealing with a noise issue with my 2015 1.4 LT. So basically, there is a buzzing noise that occurs when I step on the gas, doesn't matter how hard I do it, HOWEVER, it doesn't always happen and seems to happen whenever...
  3. General Discussion
    Do these numbers look normal ? One is no pressure the other is at WOT
  4. Gen1 Diesel General Discussion
    I've got the 2014 Diesel. I thought I would pull the throttle body off and clean it. I could not believe how bad it looked! I've got 75k on it. I think I will be cleaning it again.
  5. Gen1 Powertrain
    Anyone know what could cause this?
  6. Gen1 1.4L Turbo
    So I ordered one of these last week and attempted to install it today: 1.4L Ecotec Throttle Body Spacer by DDMWorks It fits fine, but it moves the throttle body too far down where it's hitting a coolant line/bracket that I believe goes to the heater core. My question is, am I dumb or is there...
  7. Cruze Parts
    I have both XtremeRevolution's Big 3 kit and his V1 Manifold PCV valve fix kit as well as the BNR throttle Body Spacer for sale My cruze got totaled by a deer before I got an chance to install them. All are brand new and never been installed BRN Throttle Body - $55 Big 3 Kit - $45 V1 Manifold...
  8. General Discussion
    I have to change my throttle body on my 2011 Cruze. Can anyone tell me what I need to remove the bolts that hold it on? Don't know if they are metric or sae or if they are allen or torx. thanks
  9. Gen1 Powertrain
    I just got done replacing the valve cover for the second time (first time was 2.5 years ago) due to another failed pressure regulator and noticed an oil leak. It appears to be coming from the throttle body and dripping down onto the hoses beneath. Question is, why is there oil there in the first...
  10. Cruze Parts
    Used it for 2 months, took off because of a tight with with my FMIC piping. Fits Gen 1 1.4L. Gasket is good, comes with 4 bolts. $37 shipped or $30 picked up in 92408
  11. General Discussion
    What's the difference between PID's for Absolute Throttle Position vs. Relative Throttle Position? Trying to figure out what type of value to look at for the 1.4L turbo engine, when fully warmed up, sitting at idle. 19.2% Absolute. Is that high and require a cleaning or inline? That's...
  12. Gen1 Audio, Electronics & Electrical
    Hey guys, Looking for wiring diagram for my 2013 cruze. Need the throttle body wiring pinout. Thanks in advance for any help.
  13. Gen2 Powertrain
    After watching DRE Dan (Extreme Revolution) on Youtube discus pressure leak down testing boost & vacuum system, I set up a pressure gauge in a similar fashion to that shown in the video. https://www.youtube.com/watch?v=heQYgmcGnHI&t=176s Another user informed me that max boost pressure under...
  14. Gen1 Diesel General Discussion
    Hello everybody, reading this great forum has helped me to solve many questions regarding my Cruze and I am sure, you will be able to help me out on this one also. My Chevy Cruze is 2012, Korean made, for Europe, 2.0, 163 hp, 155.000 km, manual transmission. The issues I have are: When...
  15. Gen1 Diesel General Discussion
    Someone else was referencing this lag in the Gen1 gas thread. I have a 2015 CDI and the throttle lag is killin me. It almost seems like there may be a throttle position sensor issue but there are no codes. If I press on the pedal lightly the delay is 1-4 seconds. If I mash the pedal from the...
  16. General Discussion
    Hello everyone, could please tell me, how I can get to throttle body and where it is in cruze 2.0 163 km 2012. Please help!!
  17. Gen1 1.4L Turbo
    Hey guys, here is oil accumulation right under TB and Intake Manifold. It goes down and coats the engine and trans. My dipstick shows no oil loss so it is a very slow leak. I am trying to figure out what could be leaking on this end of the engine? Cam cover is dry and dealer replaced the oil...
  18. General Discussion
    What constitutes to my throttle working well to about 25%, and past 25% to about 50% I notice a power loss, so much that releasing the throttle a bit gets my power back? The first 25% of throttle have always been the zone of my daily driving, but when I surpass about 75% of throttle, I notice a...
  19. Gen1 Service Issues
    Hello everyone, I am hoping to get some advice about an issue I had with my Cruze earlier today. The check engine light came on and I had it read at an auto parts store. The code that showed up was P2135 which indicates a throttle issue. From what I have found online, it says it could be the...
  20. Gen1 Diesel General Discussion
    Hello Everyone. I have been a following member for quite a while and have found the information in this forum very helpful. I have a 2014 CTD that i purchased in September 2013. I drive mixed 80/20 highway/city. I maintain the car well and its been very reliable for me, but I have...
1-20 of 70 Results
Top