Chevrolet Cruze Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 9 Results
  1. Gen1 Service Issues
    Hello, new member here. My name is Tina and i live in the great state of Virginia. Greetings to everyone. I'm going to cut right to the subject, i started my car this morning and all kinds of messages were coming up. here the details.... 2015 Chevy Cruze LT 110000 miles (i know....) Codes...
  2. Gen1 Powertrain
    Hi everyone. I have a 2013 Cruze Eco. Just as the powertrain warranty was about to expire, the reverse plate shattered and metal was in my transmission. I had that fixed. It started when I would put the car from reverse to drive, and there would be a long pause and then it would kick into gear...
  3. Gen2 Audio & Electronics
    I just found an old pair of ZXE's I was gonna put into the cruze until I decide to order up some LED's. Unfortunately this is my first car newer than 2000 and having some problems. I took apart the stock tubing on the passenger side to get at the dust cover, managed to get it off and then...
  4. 👋 CruzeTalk New Member Introductions
    So about a week ago I installed the zzp catless downpipe and the catted midpipe combo. No lights went on and it drove fine for that week. I started the car one morning and I heard a difference in the sound. While driving the check engine like came on. I got it scanned and it was the P0420 code...
  5. Gen1 Wheels, Tires, Brakes, & Suspension
    Hello all! I have a 2013 Cruze with about 67k miles, and I'm just about at my wits end trying to figure out what's going on with my electric vacuum pump. The car will sometimes have weak brakes within the first minute or two of running, like, there is no or limited power assist available...
  6. Gen1 Audio, Electronics & Electrical
    I've tried about 5 separate times trying to get my alpine single din installed, using the gmos044 and the aswc, my issue is I cannot get the oem screen to work. When I first tried to install I had just done what I've always done with aftermarket headunits connect and solder the corresponding...
  7. 👋 CruzeTalk New Member Introductions
    So I've discovered a hole in my plastic thermostat housing/water outlet (where all the hoses come together on the drivers side of the engine. My question is, can I just take the hoses and 3 screws off and swap the plastic housing, or do I have to change the thermostat itself as well?
  8. 👋 CruzeTalk New Member Introductions
    Hi all I'm new here and I'm having some problems with my 2011 Cruze. When I try to crank it, it's having a sluggish start and my menu screen changes by itself( I always have it on my gas milegae). This morning I tried to crank it and it seemed like it would turn over and then it died. When I...
1-8 of 9 Results
Top