Search Results for ‘wear’

I was walking by the passenger side of my car and noticed my rotor looked kind of weird. I have Centric Rotors and I believe CarQuest pads (Had Centric pads but had pad rattle so did a warranty swap, still rattled so I went to Advanced Auto to get a new set) I havent pulled my wheel off to...

I just bought my tires brand new last winter, Falken all seasons. I noticed some clunking sounds which I've discovered is worn sway bar links so I just purchased the moog links to replace them. However I'm not sure if that alone could be the cause of my tires showing an incredible amount of wear...

I have been noticing whenever I go out lately I hear this woshing noise coming from the back of the car when I apply the brakes. The front rotors are fine but the two rear rotors have uneven wear patterns on them (as seen in the pictures). I had the pads and rotors replaced less than two years...

Just noticed some very abnormal and sudden front passenger side brake pad wear on '12 Eco. Both driver side pads still has maybe 8mm left but passenger side outside pad is almost gone (inside pad not too bad...see pics below). Only thing I've done recently was pressure bled the brakes using...

I have asked about this on the facebook page with good advice however, i am hoping someone as experienced this. I replaced my original brakes and rotors. I used duralast gold rotors and their ceramic pads. I followed instructions and have changed them before on other vehicles with no problem. I...

Hi, I recently started having issues with a pulsating brake pedal on my 2011 Chevy Cruze Eco MT (50,000 miles on it), so yesterday I decided to take a look at the pads and rotors. The rear pads and drums are in serviceable condition, only needed to be adjusted. However, the front pads and...

87000 miles on these tires. Ive ran these since day one. Still have half the tread. Outstanding wear

Hello All. What has everyone else's experiences been with tire wear on their Cruze? I live in Pittsburgh were there are lots of hills and bends, and my cruze seems to be eating front tires. The OE FR710s lasted about 4K before they were at 4/32s, and then I replaced them with Cooper CS5 ultra...

Have any of you diesel owners noticed the innermost part of your tire wearing more than the rest of the tire? I just noticed this on my car. I am trying to gauge if "they all do that" or if it may have had to do with the time I had bad wheel bearings for a bit.

May have identified my low boost and poor performance problem. 2012 ltz 51k miles 6at, Low Boost With NO FAULT CODES. Check the video linked below... lots of play at the pin. I told the dealer on my last visit the loaner cruze seemed much faster but they claimed there couldn't be anything...

I'm asking this question here as this seems to be a fairly active forum and the part I am asking about is identical between the two cars. Yesterday, I just purchased a used Buick Verano, but prior to doing so, I had asked the dealer to remove this white mark that was on the steering wheel...

After 40k miles this belt is showing signs of uneven wear....... could this be the cause of a mysterious faint whistle noise ? Should a water pump or alternator pulley be replaced. The grooves are showing no signs of unsual wear and appear to be normal. Serpetine belt, tensioner and balancer...

It's been almost 2 years with my cruze now, and like all things, it starts to collect little imperfections that make you squint your eyes every time you walk by. Those tiny imperfections that make it uniquely yours. So far the biggest thing seems to be small cracks along the grille, and a number...

Would this result in brake failure, rattle, noise, would it make any difference at all? The cruse has the indicator on the inside top, what if you were to put them on the inside bottom?

Currently I have my 3rd set of oem goodyear fuel max tires equipped. My previous 2 sets were replaced at 85k miles with approximately 3/32 center and 4/32 outter grooves remaining. I tried to keep the cold tire pressure at 38 psi They had signs of inside shoulder wear. Before installing my...

Folks, Not sure if this is an old-wives tale. But I remember reading on some vehicles, don't turn on the A/C while cruising at high speed -- it generates extra belt ware as the compressor grabs hold? Also, extra wear if you keep cycling the A/C on/off just to get better mileage.... Is that...

I have a 2012 Cruze 1LT, black cloth, 4,500 miles. The seats look like the black is wearing off, almost looking white in spots. Anyone else have a problem with that? Thinking I will have to make an appt at the dealer.