[TintGuy]

Okay so I got my lightbar in yesterday and in order for it to fit in the lower bumper i removed the lower louver and cut half of the second one. It fits and looks good but now it's kicking a code. I'm not concerned over the .5mpg ill be losing with the louvers not in. Just want that light out and wondering if you guys know of a way I can fool the sensor or get rid of it.

Thanks boys.

Sent from my LG-D852 using Tapatalk

 

[TintGuy]

I took a look and the only louver I left in there was the very top one. the middle is what causes the top and bottom one to move. I figured that if I left the motor plugged in it wouldn't matter since the motor instill operational, but I may have to try and fab something to keep the middle piece moving and semi operational.

 

[TintGuy]

Oh yeah that would make sense. I guess i will have to pull the bumper again and see if we can get that light out.

Sent from my LG-D852 using Tapatalk

 

[TintGuy]

Okay update.

I took the bumper off took a look and where the fin is attached to the motor. I cut it so it's in the slot and when the motor tells it to open/close it gives it resistance.

I did that and got a guy to clear the light (fuel pump related) and went for a drive. Got the engine up to normal operating temp and varied speeds from 80kmh to 160kmh (lol)

Went on about a half hour drive and no light yet. Ill post a picture tomorrow when it is light out.

Thanks everyone for their input

Sent from my LG-D852 using Tapatalk

 

[TintGuy]

Going to look into this today as I work for a Chevy dealer we should be able to come up with something.

Sent from my LG-D852 using Tapatalk

 

[TintGuy]

Saw a similar post on the CruzeTalk Facebook page and a guy said if you change out the relay from a non Eco Cruze it will quit kicking codes. So I have my relay on order and ill put it in when I get back to town on Wensday and that should fix it for sure.... I hope