Chevrolet Cruze Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hey Guys! Before I start I hope you all have a very Merry Christmas since its right around the corner! I am trying to run my power wire to the back of the car to set up an amp. The grommet I was told to use is taken up by the clutch. I do not see any other way to run the wire from the battery back as I cannot even see a place to feed it through on the inside or from the engine compartment. Has anyone done this and had any success? Please help! Thank you!
 

·
Moderator
Joined
·
2,170 Posts
I used the hole in the firewall that the main wiring loom runs through, theres a rubber boot covering the wires located just behind the coolant surge tank
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top