Chevrolet Cruze Forums banner
1 - 3 of 3 Posts

42 Posts
Discussion Starter · #1 ·
I have installed the 94556229 TRUNK HARNESS and installed a camera on the rear.
However i don't have the UVC code on a 2015 Cruze and i don't know if that is just a wiring completion to work or the code has to be corrected on the radio.
All the wiring is from the Drivers 1/4 panel to the back of the radio.
all my connects are in place now.
the connection in the trunk has 14 wires at the main harness in the 1/4 panel which is a extra 5 wires.
.the camera has 6 wires which i believe it shares a ground wire in the trunk harness
Does anyone know where the code lives in the radio and how to program it.
I don't want to pay 200.00 to get it program by the site refereed here.
Can anyone help
Thanks In advance

Premium Member
8,012 Posts
Mods, can we move this thread to Gen1 Audio & Electronics?

sally body, that's still an area under exploration. I think it's likely that the "switch" is the 128Kbit flash chip. But we don't know the location of it. At this point I've got three different images - all from radios with the camera. If you can send your image to me, I'll see what's different on yours.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.