Chevrolet Cruze Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
117 Posts
Should be able to use the audio to the sub for inputs. Bazooka prefers the use of the high level inputs any way. I had a 100w 8 inch tube before, It was ok. The 8 inch band pass sound ordnance i also ran in the same car was decently fun! Sir mix a lot's baby got back shook the car with the band pass though it wasn't very musical.
Talk with one of the Crutchfield advisors to they can help. Good thing about Crutchfield is returns are easy if you don't like it. they for the most part can tell you all you need to install a product. I love Crutchfield.
 

·
Registered
Joined
·
117 Posts
If using the sub output's you might not need the crossover in the amp. The 250 tube has a adjustable crossover I would try it with the crossover set to the highest frequency, or you could use both crossovers together for a steeper slope.
I haven't checked how the sub is wired on your car. It likely has only speaker wires to the factory sub. If the amp is back there to it would be even easier to install as you could use the factory power and ground wires. Though only the 80 and 100w tubes are recommended for that. The 250w tubes have a 8guage wire requirement per bazooka
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top