Chevrolet Cruze Forums banner

Auto Start and Stop issues

17K views 12 replies 3 participants last post by  Rivergoer 
It's on all automatic Gen 2's, hatch or sedan.

Certain conditions will cause it not to activate. Off the top of my head, causing it never to activate during a drive cycle:
-Low battery (<12.1V)
-Cabin temp/AC usage (try Eco mode)
-Check engine light on/new battery installed
 
thanks,

check engine light is off, temp/ac is on eco mode. Battery's voltage is 14.0...

I do know the car did not start at first when I was going to test drive it so they recharged the battery. I guess it must be the battery then.
Look at voltage with ignition off (push and hold start button without foot on the brake pedal for 3-5 second or so and it will come up in 'service mode').

Mine had a new battery put in it before I got the car, likely from sitting too long in the showroom, and it was the wrong type. It should be a Group 48 AGM AC Delco in there.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top