Chevrolet Cruze Forums banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
1,544 Posts
Anyone know why start/stop wouldn't be working? It's 46°F outside according to the car's display and just got it back from the dealer
What kind of service work did you have done? It may or may not have anything to do with Auto Stop not working, depending on the work performed.

The following conditions must be met for Auto Stop/Start to function.

Initial minimum vehicle speed during the drive cycle must be 12 m.p.h. (19 km/h) or greater.Subsequent Auto Stop minimum speed may vary from 1-6 m.p.h (2-10 km/h).

Ambient engine coolant and transmission fluid temperature correlation meet specified values.

Hood switch status is closed.

Brake booster vacuum is greater than 7 psi (45kPa).

Transmission is in Drive.

Vehicle speed is less than 3 m.p.h. (5 km/h).

Engine speed is below 1,500 rpm.

Engine coolant temperature is less than 248 degrees F (120 degrees C).

Ambient temperature is greater than 40 degrees F.

No A/C compressor request from HVAC.

Battery voltage is greater than 12 V.

Battery state of charge is greater than 75 percent.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top