Chevrolet Cruze Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,082 Posts
[h=2]DTC = P16AE : Glow Plug Control Module Temperature Sensor Circuit High Voltage[/h]Additional Basic Enable Conditions:
- Engine is not in standby state (standby state occurs after ECM initialization or following after-run)
- Battery voltage is above 11V for at least 3s

So... with the cold you might have some glow plugs that are burning out.. just a guess on my part.
 

·
Registered
Joined
·
1,082 Posts
Text Font Line Parallel


Here is the Diagnostic Table, I seem to recall I was able to obtain this document from GM Tech Authority, as it is OBD 2 related it does not require a paid subscription to their service (which is very expensive).

I'd attached the entire .pdf if I could, but the forum size limit is way below the over 1 MB file size of the document. If you can't read the image here, it is just the text from the prior post... so no worries.. good luck in getting this fixed.
 
1 - 2 of 2 Posts
Top