[Limedust]

Related question:

I had a leak with my old hose, so I bought a new one with both the o-ring and plastic ring in place. I was not able to get the hose to fully snap into place (with the metal clip) on the intake with the plastic ring in place, so I pulled it thinking that maybe it was just there for shipping to ensure that the o-ring didn't fall out. Fortunately, I kept it, just in case it was actually needed.

Could someone snap a picture of the o-ring and plastic ring fully seated into the hose?

Thanks for any help!

 

[Limedust]

Following up to my own post in case anyone else reads this...

The answer is simply to press the plastic ring in as hard as you can over the o-ring without crushing the hose end (which I felt like I was close to doing). Was able to get the retaining clip to snap into place with some effort.