Chevrolet Cruze Forums banner
1 - 1 of 1 Posts

10,296 Posts
Goodbye gasket, hello RTV, good question is how much oil are you using?

Oil level at rest is below that RTV line, but splashes around, and the way yours sounds, been splashing around for good while.

Correct cure is to drop the pan, clean it and use new RTV. Cheaper way is to clean it off, wire brush the gap, found using Permatex high temperature two part epoxy works the best filling that gap. Just do this on old stuff.

What does your dealer want to reseal the pan, least a three hour job to drop it? Also not bad to make sure all of your pan bolts are tight.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.