Chevrolet Cruze Forums banner

Five8 Industries Installation log

2868 Views 18 Replies 4 Participants Last post by  landrystephane92
Hey guys, I'll be installing my Five8 Industries coil-overs soon and I'm wondering if there would be anything specific you'd like to see or know about regarding the install.

I'll be doing this by myself with my limited tool, but I'm sure I'll be fine doing so, I already swapped the front struts with another factory set but with lowering springs pre-installed and the rear is easy peasy.

I'm willing to go as in-depth as my knowledge allows me to show anything. I won't bust out the DSLR, but I can def take good log pictures of anything specific from removal down to install and adjustment.

Wheel Car Tire Vehicle Motor vehicle
See less See more
  • Like
Reactions: 1
1 - 1 of 19 Posts
So I installed the rear this weekend and as expected both sides will need different settings.

For the shock, I put the barrel spacer over the washer which is under the mounting bracket and the nylon lock nut on top. At first I tried the barrel spacer on top and there's not enough clearance.

Last picture is final height with both sides done.

View attachment 296450
View attachment 296449
View attachment 296444 View attachment 296441
View attachment 296443
View attachment 296446 View attachment 296445
View attachment 296440
View attachment 296448
I’m looking to buy these as well. Now that they are installed what’s your opinion? Likes/dislikes?
1 - 1 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.