Chevrolet Cruze Forums banner

Flashing trouble warnings,readouts, hesitation.

2407 Views 11 Replies 6 Participants Last post by  gregbonat
Left this a.m. For 2-1/2 hr commute. Service p/s lite came on momentarily. Once on hiway, noticed my scan gauge was dropping readouts. The display was staying on, but the numbers would blank out every three seconds or so. Then the needles on the instrument gauges would drop momentarily about every 1-2 min. Service p/s warning light would also come on most of these times as well. Noticed an engine hesitation each time the gauge needles would take a dive. On way back home more warning kites came on: abs, track control, and stabil trak. I pulled over and restarted engine , new warning lites did not come back on rest of trip of 20 mi. Original problem did continue however Guess another trip to dealer is in future to see if they can figure wtf is going on now. Also noticed when I pulled into garage that the flashing warning and needles dropping on gauges seemed to stop
1 - 4 of 4 Posts

· Registered
Joined
·
70 Posts
Discussion Starter · #10 ·
Well as seems to be another of those electronic gremlins. Have to wonder if it has something to do with software coding as these freak warnings and glitches happen at major mileage milestones. Anyway fluctuations just went away on their own. Even the check engine light that was on while I've been waiting for a sensor on b/o for two months has gone out.
 

· Registered
Joined
·
70 Posts
Discussion Starter · #12 ·
No, I am way out of warranty and have had no issues that seem to relate to cable. Even this last situation doesn't appear to have cable concerns. Car has had no glitches at all in past week of driving. I will however check on ordering this cable and replace as preventive measure
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top