Chevrolet Cruze Forums banner
1 - 3 of 8 Posts

· COTM Winner
2014 Cruze Diesel, 2007 Cobalt, 1981 Camaro Z28, 2017 Volt
Joined
·
7,241 Posts
Discussion Starter · #1 ·
Sounds like we have a heat shield rattle (typical thin metal ringing noise) going on somewhere in the front half of the vehicle - can't tell if its on/near the engine, or the exhaust system. I'm going to get the car on a lift to do the trans fluid here soon (hopefully), so I'm going to have a look and see.

I swear I smell something different, as well, and I only noticed it when I noticed the rattle.

Anyone have any ideas what it might be, so I can focus my initial search on that area when we have the car up?

Thanks!
 
  • Like
Reactions: vwgtiglx

· COTM Winner
2014 Cruze Diesel, 2007 Cobalt, 1981 Camaro Z28, 2017 Volt
Joined
·
7,241 Posts
Discussion Starter · #6 ·
So...had the car up on the lift at my buddy's house today. DPF heat shield was solid as a rock.

But then I looked back a few feet and immediately saw the cause.




Amazing how the car is not one decibel louder - you just smell a bit more post-SCR diesel, but other than that, hardly sounds any different.

Well then.
 

· COTM Winner
2014 Cruze Diesel, 2007 Cobalt, 1981 Camaro Z28, 2017 Volt
Joined
·
7,241 Posts
Discussion Starter · #8 ·
Or new, stainless flanges - those things don't look very healthy.
 
1 - 3 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top