Chevrolet Cruze Forums banner

Help! Service Stabilitrak/Service Power Steering/Service Traction control/low power

78796 Views 17 Replies 13 Participants Last post by  Cruzissues2023
Hi all, at my wits end trying to figure this out. I'm sure its something simple, at least I hope!

2013 Cruze LS 1.8, Auto, 75K.

For about the last month, occasionally after starting, my Service Stabilitrak, Service Power Steering, and Service Traction Control lights all come on, warnings come on the screen in that order. This is happening since its been cold. A few times when this has happened, I haven't been able to get it out of park. The selector moves, but the transmission does nothing. When it does go into gear, it "clunks" into gear, and the car is in low power mode. If I drive or idle for 5 minutes or so, I can turn the car off, wait 30 seconds, and turn it back on and all the warning lights will be off, and I can drive the car as normal. (Check engine light stays on). This can happen a few days in a row, or 4-5 days in between, and only happens either overnight or after work- when the car has been sitting for a while. NEVER happens when running errands with multiple starts.

I checked all over, and found that it might be the negative battery cable, which there was a recall for, so I replaced the cable with a new AC Delco cable. The explanation was there was not enough voltage (Bad Ground) going to the computer when starting, which caused the error codes. Once the battery got charged for from a few minutes of driving, there was enough voltage at start to not cause the error. I thought that fixed the issue, but it started happening again about 4 days later.

I don't think it is the battery itself- Before starting, on a cold morning, my multimeter it giving me 12.25-12.5 volts, and the battery is only about 6 months old.

I ran the code, and am getting U0101, $07E8, "lost communication with TCM", which when I researched, looks like I'm getting pointed back in the direction I started from- Not enough voltage causing a glitch in communication when starting.

My Alternator is good, cable and ground is good. Anybody have this same issue? I've found a few threads with similar issues, but nothing quite like this, with all three service codes + loss of power.
See less See more
1 - 1 of 18 Posts
Has anyone found an answer to this one? My car works fine for

Soooo...nobody has found the answer for this one yet? God this car is a piece of ****! Does this crap about twice a year...then all of a sudden it will start and all is fine. This morning went to the gym...get done working out, try to start car...nothing, just all of the service messages...stabilitrak, power steering, traction control....wont even try to start. Battery is good.
I have had many of the issues listed here and more with my 2013 turbo (stabilitrak, power steering, check engine, U0100, loss of can bus communication etc.. etc.. etc..).
A few weeks back I was on the highway and all these faults came up plus, I lost all my gauges (speedometer, tach, temperature etc) the transmission stayed in gear but once I pulled off the highway it would not shift and would only limp along. After sitting a while I restarted the car and it ran fine. The next morning I turned on the key and received a list of faults which pointed toward module communication failures.
This time the problem was persistent. I had already gone the dealership route and had a new battery cable installed etc. The fix for me was to remove the battery connections, pull the three connectors on the ECM module located in the engine bay near the battery, apply dielectric grease to the female sockets and reseat the connectors.

All faults immediately cleared and I haven't had an issue since.
1 - 1 of 18 Posts