[Marzen]

I ran into a problem today in that I was unable to tap into the stock stereo speaker wiring for my line out converter. 1- there is not much slack to work with up by the kick panel under the fuse box, and 2 - they are twisted pairs. I've looked at the photos that others have posted and I just can't seem to get it done. I could sure use some suggestions as I'm now stuck at about 80% shy of completing this project. Here's some pics of what I got done this weekend.
-Thanks,
Marz

View attachment 3915

I found a ground stud on the wheel well.

12vdc switched source - pigtail
View attachment 3909

 

[Marzen]

...it's all plug and play! No need to mutilate the factory wiring...

Hi,
I'd seen you post this before, but I was concerned that pulling the head unit out was beyond me.
1) Could you describe how to remove the h/u?
2) Is there a reasonable amount of slack in the wiring harness to get to the rear of the h/u?
3) How difficult is it to route the new wiring through the dash and down to the kick panel near the trunk release?

Thanks,
-Marz

 

[Marzen]

I would just do what I did for my system, but a GM-AA44 pac LOC and it's all plug and play! No need to mutilate the factory wiring...

I could not locate the GM-A44 Pac part you listed. Perhaps they have changed the p/n.

 

[Marzen]

You can get at the wires easier if you pull the panel thats behind the hood release.

Haha - 'easier' is a relative term I 'spose. I tried that same location as you Jay, but found it impossible. I spent the better part of the '80's as a radioman on a submarine so I'm used to some tight locations, but I couldn't pull this one off.
All things considered, I think I'll go with Boats4life's Pac converter behind the head unit.
I did locate a quick disconnect at Parts Express so I can remove the sub/amp from the trunk when needed.
Here's a link to the quick disconnect if anyone is interested (you'll need to purchase two):
SMH SY175 Series 4 AWG 175A Breakaway DC Power Connector 263-120

 

[Marzen]

Someone was good enough to post a link to this foreign youtube video showing how most of the center console & trim is removed. They do make it look easy.
http://www.youtube.com/watch?v=etNo4pHAo_0&list=FLuGjCG6YUBEPgbe3VyVt1cQ&index=1&feature=plpp_video
Boats, can you comment on what parts seem necessary to just get to the back of the radio?

Thanks

 

[Marzen]

You have to disconnect the modular block wiring connector on the back of the stereo, then attach the PAC modular connector to the stereo, then reattach the vehicles wiring connector to the other side of the PAC unit. The PAC unit has a 'T' for a wiring harness - meaning it attaches between the stereo and the car's wiring. Stuff the PAC unit on the right side of the radio compartment (left side of the glove box. It's a tight little area but it will work as there is no room behind the radio.